OM-1273-004_w - 第56页
1-19 AJK-ML T-ID 0706-002 3.3 Magazines • Detachment of Magazine (1) Move the magazine to be replaced to the magazine change position by means of the operation monitor . Note While the magazine is moving, the LED of the …
1-18
AJK-MLT-ID
0706-002
(3) Hold the handle in the magazine base and slowly pull it out until it
stops.
Handle
Fig. A8 Magazine Base (Drawer)
(4) Hold the handle of the magazine and slowly put it on the magazine
base. Then, push it against the rear stopper.
Conrm that the magazine has tted to the side faces and the rear
stopper without being tilted.
(5)
Hold the handle of the magazine base and slowly push the base toward
the rear side until it touches the rear side.
(6) While pulling the magazine stopper knob forward, turn it
counterclockwise by 90
°
.
Then, return the magazine stopper back in
place.
When the magazine is located at its home position, it is locked by the
magazine stopper.
(7) Close the magazine exchange door and press the ready switch.
The magazine exchange door is locked electromagnetically and the
LED of the ready switch illuminates.
Note
This machine keeps the last component ID matrix position in memory
even after the current program (model) is changed to another one.
Before reloading the tray in the middle of process with some
components after the current program (model) is changed to another
one, it is required to change the matrix because some components are
left behind (not picked up).
3.3 Magazines
1-19
AJK-MLT-ID
0706-002
3.3 Magazines
•
Detachment of Magazine
(1)
Move the magazine to be replaced to the magazine change position by
means of the operation monitor
.
Note
While the magazine is moving, the LED of the [READY] switch
ickers in green.
When the magazine reaches the magazine change position, the LED
of the [READY] switch extinguishes.
(2) Conrm that the LED of the [READY] switch is "OFF" and pull the
door handle forward to open the door.
(3) While pulling out the magazine stopper knob forward, turn it clockwise
by approximately 90
°
.
(4) Hold the handle in the magazine base and slowly pull it out until it
stops.
Notice
Be sure to pull out the magazine base slowly. Otherwise, the
magazine will drop forward by itself.
(5) Shift the magazine a little forward and take it out.
1-20
AJK-MLT-ID
0706-002
3.4 Traverse
The traverse is provided with a mechanism that pulls out a pallet from the
magazine.
A pallet is pulled out at the specied position from the magazine and
transferred to the component pickup position.
After the components have been picked up, the pallet is stored in the
magazine.
Traverse
Fig. A9
3.4 Traverse