00196376-0102_UM S-Feeder_EN - 第62页
Bulkcase Feeders Maintenance Cleaning and Greasing the Lifting Magnet on the Body 62 User Manual SIPLACE S-Feeder Lifting magnet ► Clean both lifting magnet to re move any components. ► Grease both liftin g magnet with a…
Bulkcase Feeders
Maintenance Intervals Maintenance
User Manual SIPLACE S-Feeder 61
3.4 Maintenance
Maintenance work needs to be performed to the body and the feeder track of the bulkcase feeder. The
service intervals depend on the feeder operating environment (degree of contaminants).
You need to clean and grease the lifting magnet on the body.
You also need to clean the component duct on the feeder track.
3.4.1 Maintenance Intervals
▪ The lifting magnet on the body needs to be cleaned and greased when the component cover no
longer opens properly.
▪ The component duct on the feeder tracks needs to be cleaned when the components are no longer
fed through properly.
3.4.2 Consumables and Tools
▪ Lint-free cloth
▪ Alcohol
▪ Topas Isoflex ® (Item No. 02102561-01)
3.4.3 Cleaning and Greasing the Lifting Magnet on the Body
►Remove the feeder tracks from the body.
Lifting magnet cover
►Remove the two screws (1) and then the lifting magnet cover (2).
Under the cover you will find the lifting magnet with the lifting magnet.
Legend:
1 Lifting magnet screws
2 Lifting magnet cover
Bulkcase Feeders
Maintenance Cleaning and Greasing the Lifting Magnet on the Body
62 User Manual SIPLACE S-Feeder
Lifting magnet
►Clean both lifting magnet to remove any components.
►Grease both lifting magnet with a little Topas Isoflex ®. Only apply a very small amount of grease to
the areas shaded in the diagram.
►Now fit the lifting magnet cover.
Legend:
1 Lifting magnet (only grease shaded areas)
2 Contact surface of lifting magnet (no grease)
3 Damping material
CAUTION
Do not apply any grease to the contact surfaces of the lifting magnet. Clean the contact surfac-
es with a dry, lint-free cloth, if required.
Bulkcase Feeders
Cleaning the Component Duct on the Feeder Tracks Maintenance
User Manual SIPLACE S-Feeder 63
3.4.4 Cleaning the Component Duct on the Feeder Tracks
Component duct on the feeder track
►Loosen the 8 screws fastening the holddown.
►Remove the duct cover.
►Loosen the screw fastening the component stop (3).
►Remove the component stop.
►Loosen the screw fastening the light barrier (2).
►Pull the light barrier out until you can access the component duct.
Make sure that the cables and connections are not damaged.
►Clean the entire length of the component duct with alcohol.
Make sure that you do remove any of the labels attached to it.
►Now rub the cleaned component duct dry with a lint-free cloth.
►Fit the component stop so that it is positioned at the end of the duct (5).
►Fit the duct cover level with the funnel and position it against the holddown.
►Fit the feeder tracks back on the body.
Legend:
1 Holddown 4 Component duct
2 Light barrier 5 The component stop must lie against the component duct here.
3 Component Stop 6 Duct cover