00196376-0102_UM S-Feeder_EN - 第65页
Linear Vibratory Feeder, Type 3 Function User Manual SIPLACE S-Feeder 65 4 Linear Vibratory Feeder, Type 3 4.1 Function The vibrato ry feeder is used fo r processing components in stic k magazines. The component stick ma…
Bulkcase Feeders
Maintenance Cleaning the Component Duct on the Feeder Tracks
64 User Manual SIPLACE S-Feeder
Linear Vibratory Feeder, Type 3
Function
User Manual SIPLACE S-Feeder 65
4 Linear Vibratory Feeder, Type 3
4.1 Function
The vibratory feeder is used for processing components in stick magazines.
The component stick magazines consist of profiles, which are available in the appropriate sizes for all
common components. When using a vibratory feeder, up to 3 tracks can be addressed by the placement
machine, depending on the size of the components.
The components are transported into the pickup position by a linear vibratory feeder.
4.2 Component Stick Magazines
Component stick magazine
Legend:
1 Raised pickup position
2 Red marking for refill monitoring
3 Refill opening outside the protective cover
4 Item number on the underside of the component stick magazine
5 Fixture aid on the underside, for precise positioning at the back
6 Fixing pin on the underside, for precise positioning at the front
Linear Vibratory Feeder, Type 3
Component Stick Magazines
66 User Manual SIPLACE S-Feeder
▪ Component stick magazines can be refilled without the machine being stopped, as the refill opening
is located outside the protective cover on the placement machine.
▪ The length of component stick magazines is designed to completely accommodate all component
packaging magazines currently available on the market.
▪ Most component stick magazines have an approx. 12 cm red marking (2) next to the pickup position,
which tells the operator when components need to be refilled at the latest. The component stick
magazines should therefore always be refilled at least up to the far end of the red marking.
▪ The item number of each stick magazine is marked on the underside of the magazine end for easier
identification.
▪ To increase the function reliability, the component stick magazines are fixed to the basic feeder part
with small pins (5 6) at both ends of the vibratory feeder.
To profit from this increased function reliability, always make sure that the component stick maga-
zines are fitted correctly at the back and then at the front on the vibratory feeder.
▪ The new fixing pieces are designed to fit all magazine sizes, so that there is no need to replace the
fixing piece when you change the magazine.
▪ Vibratory feeders of previous series can be retrofitted for use with the new fixing pieces. The retro-
fitting kit can be ordered with the Item No. 00310741-xx.
A retrofitted vibratory feeder can also accommodate older magazine models.
▪ To facilitate pickup of special components, the pickup position (1) is raised above the magazine
guidance by 0.3 mm.
WARNING
The long component stick magazines protrude above the tape container and out of the place-
ment machine. There is a risk of injury at the unprotected, sharp edges of the component stick
magazine.
Only use component stick magazines with protective "bumper" edges.
Fit any unprotected component stick magazines with protective edges.
Protective edges can be ordered from the spare parts catalogue.
The fitting of protective edges is described in the "Retrofitting Guide for Protective Edges on
Vibratory Feeders", Item No. 00192925-xx.