00198829-01_SM_X-Series-S_Hxxxx_EN - 第27页

2 Basic Machine 2.4 Setting the Covers Service Manual SIPLACE X-Series S (from Hxxxx) 01/2021 27 2.4 Setting the Covers 2.4.1 Overview Fig.12: Overview of Settings 1. Setting the cover switch See 2.4.2 "Setting the…

100%1 / 382
2 Basic Machine
2.3 Guide Rollers on the Covers
26 Service Manual SIPLACE X-Series S (from Hxxxx) 01/2021
Removal/installation
► To make the work easier:
Dismantle the bottom stop.
Fig.11: Threaded pin
► Loosen the threaded pin and twist the roller out.
► Insert the new roller.
► From the inside, screw on a threaded pin as lock and tighten it.
Checks
► Between the roller and the guidance there must be at least 75% coverage along the entire
length of the guide rails.
► Check whether the cover can be easily moved along the whole area. Adjust the cover if ne-
cessary.
2.4 "Setting the Covers" [}27]
2 Basic Machine
2.4 Setting the Covers
Service Manual SIPLACE X-Series S (from Hxxxx) 01/2021 27
2.4 Setting the Covers
2.4.1 Overview
Fig.12: Overview of Settings
1. Setting the cover switch
See 2.4.2
"Setting the Cover
Switch" [}27]
2. Setting the cover switch centering
See 2.4.3
"Setting the Cover Switch
Centering Device" [}28]
3. Setting the actuator
See 2.4.4
"Setting the Actuator" [}29]
4. Setting the bottom stop
See 2.4.5
"Setting the Bottom
Stop" [}29]
5. Setting the rollers
See 2.4.6
"Setting the Cover
Rollers" [}30]
2.4.2 Setting the Cover Switch
Fig.13: Cover switch (example of SIPLACE SX2 shown)
Cover switch [03055262-xx]
► Loosen the screws fastening the cover
switch, the centering device and the ac-
tuator, so that the assemblies can be
easily moved.
CAUTION
Screws on actuator
With enforcement of the Machinery Directive DIN EN 1088 (2009), the following has been
executed to avoid misuse (e.g. putting the safety features out of action): the actuator and
machine protective switch screws have been replaced by Torx screws with pins. The relev-
ant set of tools may only be used for performing repair work.
2 Basic Machine
2.4 Setting the Covers
28 Service Manual SIPLACE X-Series S (from Hxxxx) 01/2021
Fig.14: Cover switch (example of SIPLACE SX2 shown)
► Close the cover far enough for the ac-
tuator to be just over the switch. Align
them so that the metal bracket is paral-
lel to the opening in the switch. The
metal bracket may not scrape against
the cover switch.
► Tighten the cover switch screws in this
position.
See also
2 4.4 "Replacing the cover switch" [}72]
2.4.3 Setting the Cover Switch Centering Device
Fig.15: Cover switch (example of SIPLACE SX2 shown)
► Close the cover a little more until the
plastic centering device for the actuator
is against the cover switch centering
device. These two must be centered to-
wards one another.
► Tighten the screws for the cover switch
centering device.