Printer 710-810 v9 Covers - 第43页

COVERS PRINTER COVERS Chapter Issue 10, Jul 16 Technical Reference Manual 3.43 T o remove the safety cover , remove the two securing screws. Rear Corner Panels T o remove the rear corner pa nels, carry out the following:…

COVERS

PRINTER COVERS

3.42 Technical Reference Manual Chapter Issue 10, Jul 16

Upper Rear Panel

MANDATORY

HEAVY OBJECT. LIFTING OR RESITING MUST BE UNDERTAKEN BY TWO

PEOPLE.

To remove the upper rear panel, carry out the following:

1. Using a 4mm Allen key, undo the four captive screws.

2. Lift the panel clear of the printer frame, taking care not to damage the earth

cable.

Safety Covers Safety covers are fitted to the side panels to protect personnel from inadvertent

access to the board entry/exit ports.

M5 Captive

Screws

M5 Captive

Screws

Rear Left Quarter View

COVERS

PRINTER COVERS

Chapter Issue 10, Jul 16 Technical Reference Manual 3.43

To remove the safety cover, remove the two securing screws.

Rear Corner Panels To remove the rear corner panels, carry out the following:

1. Remove the Left Hand Safety Cover (as detailed previously).

2. Remove the Right Hand Safety Cover (as detailed previously).

3. Using a 4mm Allen key, undo the appropriate four captive screws.

4. Lift the panel clear of the printer frame, taking care not to damage the earth

cable.

5. Repeat Steps 3 and 4 for the other rear corner panel, if required.

Upper Front Corner

Panels

To remove the upper front corner panels, carry out the following:

1. Open the front printhead cover.

Safety Cover Securing Screws

Front Left Quarter View

Captive Screws

COVERS

PRINTER COVERS

3.44 Technical Reference Manual Chapter Issue 10, Jul 16

NOTE

1. Before a front corner panel can be removed, the control switches (jog

switch and system switch) must be disconnected.

2. To disconnect the system switch and jog buttons carry out the following:

a. Locate the two release slots in the contact assembly part of the switch.

b. Insert the switch release tool (Part No 188647) into the slots and push

until the release tool clicks into place.

c. Leaving the switch release tool in position, pull the contact assembly from

the switch body.

d. Remove the switch release tool from the contact assembly.

Contact AssemblySwitch Body

Release SlotRelease Slot

View on Rear of Switch

Switch Release Tool

Switch Body

Contact Assembly