03217917-01-01E By DEK Technical Reference Manual Vol 1_enPDFA - 第176页
12 MACHINED C CHASE MODULE 12.4 CALIBRATIONS 176 TECHNICAL REFERENCE MANUAL Vol 1 E By DEK 04/2019 12.4 CALIBRATIONS 12.4.1 Chase to Table Level Chase to Table Level setting is factory set and no attempt should be made t…
12 MACHINED C CHASE MODULE
12.3 ADJUSTMENTS AND SETTINGS
TECHNICAL REFERENCE MANUAL Vol 1 E By DEK 04/2019 175
To set the screen depth adjuster, use the following procedure:
► Release the locking adjustment knob (3) by turning it anti-clockwise.
20”
24”
650
TO
FRONT
OF
IMAGE
REAR
OF
STENCIL
CENTRE
JUSTIFIED
IMAGE
SIZE
2
3
1
► Set the measurement guide (1) to either:
The rear of stencil to front of image value, on the top scale, for either centre or front justified sten-
cils.
or
The board width value, on the centre justified image size scale, for centre justified, 29 inch by 29
inch stencils only.
► Turn the locking adjustment knob (3) clockwise to secure the measurement guide.
12.3.2 Screen at Centre Sensor
The Screen at Centre Sensor position is fixed. When fitting a replacement sensor, the sensitivity
adjustment screw should be turned clock-wise to the ‘Max’ position before attaching the sensor to
the sidewall of the C Chase.
1
2
1 Front Face of Sensor 2 Stencil at Centre Sensor
12 MACHINED C CHASE MODULE
12.4 CALIBRATIONS
176 TECHNICAL REFERENCE MANUAL Vol 1 E By DEK 04/2019
12.4 CALIBRATIONS
12.4.1 Chase to Table Level
Chase to Table Level setting is factory set and no attempt should be made to make adjustment. If
the Chase to Table Level reading is suspected, a coplanarity procedure must be carried out before
commencing printing. Please contact your local customer support office for more detail.
13 ADJUSTABLE WIDTH STENCIL MOUNT
13.1 OVERVIEW
TECHNICAL REFERENCE MANUAL Vol 1 E By DEK 04/2019 177
13
ADJUSTABLE WIDTH STENCIL MOUNT
13.1 OVERVIEW
1
3
2
4
5
6
7
8
9
15
10
11
12
13
14
1 Roller Counter Plate (4 positions) 9 Stencil Clamp Lever (6 positions)
2 Stencil Location Leaf Spring
(3 positions)
10 Left Hand Chase Rail Release
Button
3 Stencil Clamp (6 positions) 11 Stencil Clamp Lever Actuator Bar
Guide (6 positions)
4 Stencil Support Plate (2 positions) 12 Stencil Clamp Lever Actuator Bar
5 Right Hand Chase Rail Release
Button
13 Stencil Clamp Pneumatic
Cylinder (2 positions)
6 Stencil Width Measuring Scale 14 Width Locking Mechanisms
(Rear)
7 Width Locking Mechanisms
(Front)
15 Chase Rail Assembly Guide Shaft
(Rear)
8 Chase Rail Assembly Guide Shaft
(Front)
The AWSM module provides a receptacle for the stencil, where it is clamped in the correct position
for printing. The module width can be easily adjusted to accommodate stencils from 29 inches
through to 12 inches square with 250mm belt support plates, or 29 inches through to 23 inches
square with 500mm belt support plates.
NOTE
The height of the stencil must exceed 19mm to be clamped firmly.
The stencil image can be front or centre justified.