03217917-01-01E By DEK Technical Reference Manual Vol 1_enPDFA - 第239页
16 TRANSPORT RAILS MODULE 16.4 ADJUSTMENTS AND SETTINGS TECHNICAL REFERENCE MANUAL Vol 1 E By DEK 04/2019 239 ► Using feeler gauges, check that the gap between the rear board clamp and the belt support plate is 0.325mm +…
16 TRANSPORT RAILS MODULE
16.4 ADJUSTMENTS AND SETTINGS
238 TECHNICAL REFERENCE MANUAL Vol 1 E By DEK 04/2019
► Place a board (3) across the top of the rails (not on the belts) as shown in the graphic below:
View on Arrow
12
3
► Press the SET button (1) on the sensor. The status LED (2) remains on for approximately 2
seconds.
► Remove the board (3) from the top of the rails, ensure that the status LED (2) remains OFF.
► Place the board (3) on the transport belts covering the sensor, ensure that the status LED (2)
is lit.
► Move the board back and forth on the belts ensuring that the status LED switches at the point
that the board is meant to stop.
NOTE
The sensor is mounted on an adjustable bracket so that the stop position may be altered and the
sensor can be adjusted in the X and Y directions to avoid large holes or cut-outs.
On completion of adjustment, refit the top safety cover removed previously.
16.4.3 Board Clamp Setting
WARNING
BOARD CLAMPS. EXTREME CARE MUST BE EXERCISED WHEN WORKING IN
THE TOOLING AREA OF THE MACHINE TO AVOID INJURY. THE FOILS ON THE
FRONT AND REAR BOARD CLAMPS ARE VERY SHARP.
NOTES
1. Board clamps are used in the following procedure, the procedure is identical for foil-less
clamps and snuggers.
2. If carrying out the setting on 500mm board clamps, it is recommended to remove the board
clamp foils prior to commencing this procedure to allow for thorough checking of the gap
between the rear board clamp and the belt support plate.
Rear Board Clamp Gap Check
► Remove the belt guide (1) from either side of the belt support plate (2) on the rear rail.
1
1
2
16 TRANSPORT RAILS MODULE
16.4 ADJUSTMENTS AND SETTINGS
TECHNICAL REFERENCE MANUAL Vol 1 E By DEK 04/2019 239
► Using feeler gauges, check that the gap between the rear board clamp and the belt support
plate is 0.325mm +/-0.025mm. Ensure that the rear board clamp is parallel to the belt support
plate.
NOTE
Care is to be taken when using feeler gauges to avoid damaging board clamp foils.
1
2
3
4
1
3
5
1 Rear Board Clamp 4 Cross Section of Rear Rail
Assembly
2 Moving Rail 5 View on Rear Board Clamp
3 Belt Support Plate
16 TRANSPORT RAILS MODULE
16.4 ADJUSTMENTS AND SETTINGS
240 TECHNICAL REFERENCE MANUAL Vol 1 E By DEK 04/2019
Rear Board Clamp Gap Adjustment
► 500mm Board Clamps Only. Remove the four board clamp securing screws (1) and lift off the
board clamp. Retain the four screws (1).
1
2
2
500mm Board Clamp Mechanism
► 500mm Board Clamps Only. Slacken the two location plate securing screws (2).
2
2
► 500mm Board Clamps Only. Place the board clamp in position, but do not fit the securing
screws.
► 250mm Board Clamps Only. Slacken the two location plate securing screws through the
access slots.