03217917-01-01E By DEK Technical Reference Manual Vol 1_enPDFA - 第35页
3 SAFETY FEATURES 3.5 LOCKOUT TECHNICAL REFERENCE MANUAL Vol 1 E By DEK 04/2019 35 3.5 LOCKOUT 3.5.1 Electrical Lockout W ARNING LETHAL VOL T AGE. DANGEROUS VOL T AGES EXIST IN THIS EQUIPMENT . ENSURE ALL ELECTRONIC COVE…
3 SAFETY FEATURES
3.4 HIGH VOLTAGE PROTECTION
34 TECHNICAL REFERENCE MANUAL Vol 1 E By DEK 04/2019
M36SK03
M36SK01
M36SK02
M36SK04
M36SK07
M36SK05
M36SK06
M36PL08
M36SK09
M36SK10
M36SK11
M36SK12
M36SK13
M36SK14
M36SK15
M36SK16
M36SK17
M36SK18
M36SK19
M36PL20
M36SK21
M36SK22
M36SK23
M36SK24
M36SK25
M36PL26
1
Typical Module Earth Stud and Label
1 Earth Studs and Labels (PC/M27/M36/M37/M39)
3 SAFETY FEATURES
3.5 LOCKOUT
TECHNICAL REFERENCE MANUAL Vol 1 E By DEK 04/2019 35
3.5 LOCKOUT
3.5.1 Electrical Lockout
WARNING
LETHAL VOLTAGE. DANGEROUS VOLTAGES EXIST IN THIS EQUIPMENT.
ENSURE ALL ELECTRONIC COVERS AND MAIN MACHINE COVERS ARE FITTED
BEFORE OPERATING THIS EQUIPMENT.
Electrical lockout of the printer is achieved by applying a padlock, or any other suitable locking
device, through the body and the switch shroud of the mains isolator switch. This can only be
achieved when the mains isolator switch is in the OFF position.
To electrically lockout the printer, carry out the following procedure:
► Close down the printer software.
► Switch the mains isolator (2) to the OFF position.
► Pull the lockout tab out (1).
► Fit a padlock or suitable locking device through the lockout point.
1
2
NOTE
Switch shown in the OFF position.
► This completes the electrical lockout.
3 SAFETY FEATURES
3.5 LOCKOUT
36 TECHNICAL REFERENCE MANUAL Vol 1 E By DEK 04/2019
3.5.2 Pneumatic Lockout
WARNING
COMPRESSED AIR. COMPRESSED AIR SHOULD NEVER IMPINGE UPON THE
BODY. PORTS, PIPES, ETC MUST NEVER BE BLOCKED BY HAND. BEFORE
CONNECTING OR DISCONNECTING ANY PNEUMATIC COMPONENTS, ENSURE
THE COMPRESSED AIR SUPPLY HAS BEEN DISSIPATED AND DISCONNECTED
FROM THE MACHINE.
Pneumatic lockout of the printer is achieved by:
► Close down the printer software.
► Switch the electrical mains isolator to the OFF position.
► Turn OFF the factory’s main pneumatic supply to the printer.
► Dissipate remaining air in the pneumatic supply line.
► Disconnect the pneumatic supply line from the printer.
► This completes the pneumatic lockout.