03217917-01-01E By DEK Technical Reference Manual Vol 1_enPDFA - 第96页
9 MACHINE CONTROL 9.1 OVERVIEW 96 TECHNICAL REFERENCE MANUAL Vol 1 E By DEK 04/2019 The NextMove ES card incorporates a USB encoder/decoder and a CAN encoder/decoder interfa- cing between the PC and the following: ● Next…
9 MACHINE CONTROL
9.1 OVERVIEW
TECHNICAL REFERENCE MANUAL Vol 1 E By DEK 04/2019 95
9
MACHINE CONTROL
9.1 OVERVIEW
8
7
6
5
4
3
2
1
1 Servo Node 7
Print Carriage Motor
5 I/O Node Board 2
Main Machine I/O
2 I/O Node Board 3
Print Carriage I/O - Behind Panel
6 I/O Node Board 4 Stencil Cleaner
I/O - With Fabric Feed Brake
Module
3 Servo Node 6 Rising Table Motor 7 Servo Node 9 Camera Y Motor
4 I/O Node Board 1 (NextMove ES)
- Inside Machine Control
Enclosure
8 Servo Node 8 Camera X Motor
All machine functions are initiated by the DEK software installed on the PC. The PC transmits and
receives information to the NextMove ES card in the M36 Machine Control Enclosure using a
single USB lead. The NextMove ES card incorporates its own processor which handles machine
motions and switch/sensor feedback, this frees up the PC processor to run the MMI and other peri-
pherals.
9 MACHINE CONTROL
9.1 OVERVIEW
96 TECHNICAL REFERENCE MANUAL Vol 1 E By DEK 04/2019
The NextMove ES card incorporates a USB encoder/decoder and a CAN encoder/decoder interfa-
cing between the PC and the following:
●
NextMove Interface Card
●
Stepper Drive Cards
●
EF Servo Drive Cards
●
I/O Node Boards (via CAN Bus)
●
Servo/Stepper Nodes (via CAN Bus)
CAUTION
ANTI-STATIC HANDLING. STANDARD PRECAUTIONS MUST BE ADHERED TO
WHEN HANDLING ELECTRONIC CARDS AND CONFIGURING AND INSERTING
INTO THE ENCLOSURES.
NOTE
ASM recommends an antistatic wrist band that incorporates a 1 meg ohm resistor.
9 MACHINE CONTROL
9.2 ELECTRICAL SCHEMATIC
TECHNICAL REFERENCE MANUAL Vol 1 E By DEK 04/2019 97
9.2 ELECTRICAL SCHEMATIC
Servo Node 8
Camera X Motor
Servo Node 9
Camera Y Motor