CP-7[732-742]-series Mechanical Reference(2.9E) - 第170页

D1, D2 Retract Area (Lower direction check) Inner sensor Outer sensor C7SM4053a Block (DCPJ0070) Sensor bracket C7SM4052a Block (DCPJ0060) Sensor bracket Part 4 Chapter 1 Station Adjustments Edition 2.4 4-1-20 CP-7 serie…

D1, D2 Retract Area (Upper direction check)

Inner sensor

Outer sensor

<CP-732E, CP-742ME>

<CP-742E>

C7SM4057a

Sensor bracket

Block (DGPJ5070)

Block (DCPJ0050)

C7SM4051a

Sensor bracket

Block

(DCPJ0040)

Sensor bracket

C7SM4050a

Part 4 Chapter 1 Station Adjustments

Edition 2.4 4-1-19 CP-7 series Mechanical Reference

D1, D2 Retract Area (Lower direction check)

Inner sensor

Outer sensor

C7SM4053a

Block (DCPJ0070)

Sensor bracket

C7SM4052a

Block (DCPJ0060)

Sensor bracket

Part 4 Chapter 1 Station Adjustments

Edition 2.4 4-1-20 CP-7 series Mechanical Reference

1.6.2 Sensor Amp Adjustment

Open the front cover and follow the procedures below.

1. Check that the output dip switch is set to "L ON".

2. Set the power modes and timer modes as detailed below.

2-1. Press and hold down the MODE button for three seconds or more to change

the display to "turb".

Use the up and down arrow buttons to set the power mode to "SUPER".

2-2. Press the MODE button to change the display to "dLy".

Use the up and down arrow buttons to set the timer mode to OFF.

2-3. Press the MODE button again to return the display to the original state.

3. Press the MODE button to toggle the display from the light value, to the

percentage value (value + "P"), and then back to the light value.

Ensure that the figures for all the sensors are above the minimum values shown

below.

• CP-732E

Pickup area: 1000 digit (target: 2000 digit)

Retract area: 200 digit (target: 500 digit)

• CP-742ME

Pickup area: 1000 digit (target: 2000 digit)

Retract area: 100 digit (target: 300 digit)

• CP-742E

Pickup area: 1000 digit (target: 2000 digit)

Retract area: 30 digit (target: 100 digit)

Note: The sensor should be replaced when the light reading is at approximately 4095.

Check the following items if the light reading does not reach the minimum

required value.

a The position of the sensor bracket.

b Check that the sensor is correctly attached to the sensor bracket.

c The positioning of the fiber and attachment tips.

d Check whether the fiber and amp connections are correctly inserted.

e Check the condition of the fiber wiring.

SET

SUPER

TURBO

FINE

SET

40ms

10ms

OFF

MODE

D ON L ON

C7SM4023a

Feeder sensor amp

Output dip switch

[MODE] button[SET] button

[ ▼

•

▲ ]

button

Power mode Timer mode

Open the cover

Part 4 Chapter 1 Station Adjustments

Edition 2.4 4-1-21 CP-7 series Mechanical Reference