CP43操作手册.pdf.pdf - 第115页
Chapter 7 Fiducial Mark Recovery Command Part 2 7. Fiducial Mark Recovery Command If any part is placed on a fiducial mark, or the board geometry pr events proper reading of a fiducial mark, pr oduction may be stopped. P…
Chapter 6 Nozzle Statistical ProcessingPart 2
2 – 46Version 2.0
FCP IV-3 Operation
Chapter 7 Fiducial Mark Recovery CommandPart 2
7. Fiducial Mark Recovery Command
If any part is placed on a fiducial mark, or the board geometry prevents proper
reading of a fiducial mark, production may be stopped. Production can be
restarted by setting the Proper data so that a fiducial mark read sequence is
automatically skipped or by manually entering the coordinates of the fiducial
mark.
This function is available only for a fiducial mark.
From hereon, this function will be called Mark editor.
7.1 How to Enter the Mark Editor Screen
If a fiducial mark read error occurs, display the Mark Editor screen either
by specifying the Proper data and pressing the Reset switch, or manually
selecting commands.
To display the Mark Editor screen, specify 11: Machine_Status A in
Proper data as described in 7.2, Proper Data Setting.
To display the Mark Editor screen by entering commands, Proper data
setting is not required.
7.2 Proper Data Setting
Proper data setting to display the Mark Editor screen just by pressing
Return after a mark read error occurs:
Proper data to be set: 11: Machine_Status A
Enter as follows: XXXX XXXX XXXX XXX1
(Set the last bit to "1".)
2 – 47Version 5.0
FCP IV-3 Operation
Chapter 7 Fiducial Mark Recovery CommandPart 2
7.3 Actual Operation and the Command System
7.3.1 Displaying Mark Editor Screen
Select the Automatic and then the Step commands to display Mark
Editor command at the F3 position at the bottom of the screen. This
command is available irrespective of Proper data setting.
(Note that "Mark Editor" will not display for a production program
in which a fiducial mark is not used.)
Select F3(Mark Editor) and a message to prompt the operator to
enter a sequence no. of the mark displays.
Page 130
RETURN
ST1
ST2
ST3
ST4
ST5
ST6
ST7
N
N
N
N
N
N
N
3 D 5 Er ****
3 D 5 Er ****
3 D 5 Er ****
3 D 5 Er ****
3 D 5 Er 0
3 D 5 Er 0
3 D 5 Er 0
STATUS
P Mode Product
Recovery 3 times
T mode Joint
Ready
Sequence No:
Input Mark Sequence No.
Page 130
CAM
ORG.POS
RETURN
ST1
ST2
ST3
ST4
ST5
ST6
ST7
N
N
N
N
N
N
N
3 D 5 Er ****
3 D 5 Er ****
3 D 5 Er ****
3 D 5 Er ****
3 D 5 Er 0
3 D 5 Er 0
3 D 5 Er 0
STATUS
P Mode Product
Recovery 3 times
T mode Joint
Press START.
MARK
EDITOR
SEQ.NO. MODE
2 – 48Version 5.0
FCP IV-3 Operation