CP43操作手册.pdf.pdf - 第141页
FCP IV -3 Operation •Action of the Function Keys RETURN : Press to r eturn to Page 000/000. • Second Status Area Sequence No_ • Input from Numerical Keyboard When this command is selected, the machine will wait for the o…
• Action of Function Keys
RETURN : Press to cancel any entry on this screen and
return to Page 100/000.
• First Display Area
ST1 N 3 D 5 Er ···· Status
ST2 N 3 D 5 Er ···· P mode Product
ST3 N 3 D 5 Er ···· Recovery 3 Ttimes
ST4 N 3 D 5 Er ···· T mode Joint
ST5 N 3 D 5 Er 0
ST6 N 3 D 5 Er 0
ST7 N 3 D 5 Er 0
Input Mark Sequence No.
• First Status Area
MARK EDITOR
• Second Status Area
Sequence No:
After entering a sequence no., press Start to move the camera
just above the specified mark. After that, the screen changes to
the Mark Editor screen.
Refer to Part 2, Chapter 7, "Fiducial Mark Recovery Command"
for details.
• Function Key Menu
Chapter 3 Description of Commands
To Page 100/000
Recover from Fiducial Mark
Read Error
Part 3
3 – 15
MARK EDITOR
Page
130 000
RETURN
Version 5.0
FCP IV-3 Operation
FCP IV-3 Operation
•Action of the Function Keys
RETURN : Press to return to Page 000/000.
• Second Status Area
Sequence No_
• Input from Numerical Keyboard
When this command is selected, the machine will wait for the operator to input a
sequence number. From the numerical keypad, input the sequence number from
which production is to be started and press the carriage return [CR] key.
The sequence number of a skipped sequence can be input. In this case, production
starts from the next non-skipped sequence following this number.
The sequence number must be input once again if the first sequence number input
exceeds the number of sequences in the program.
Chapter 3 Description of Commands
Inputting the Start Sequence
Number
Part 3
3 – 16
SEQ. NO
Page
140 000
Version 5.0
FCP IV-3 Operation
Press this key to cycle the operation mode between the settings listed below.
The current operation mode is displayed in the machine status area.
PRODUCT : Normal production.
SIMULATE : Currently not supported.
IDLE : Does not pick up parts or carry out vision processing. Boards are
not fed out of the machine. The tape feeders feed parts from the
tape.
Note : The production mode (PRODUCT) is automatically set when the machine power is
turned on.
Chapter 3 Description of Commands
Selecting the Operation Mode
Part 3
3 – 17
MODE
Page
150 000
Version 5.0