CP43操作手册.pdf.pdf - 第36页
Chapter 4 The Display Part 1 The relationships between the displays above ar e shown in the V enn diagram below . If the device check function is not used, the setting of parts can only be cancelled or completed using th…
Part 1 Chapter 4 The Display
T Mode: This item indicates which of the device table
modes are in operation.
Joint The two tables move jointly.
1A 2A Device Change Mode: One device table is used
as the spare table for the other table.
1A 2B Changeover Mode: Only one table operates and
each table operates for a separate program.
In both the device change mode and changeover mode the
table displayed on the outer side (left or right) is the table being
resupplied.
The color of the display takes on the following meanings;
Green Original table with device check and
the parts set operation complete
Yellow Device check and the parts set operation
complete on the table that is not the
original table
White Device check completed, parts set
operation not complete
Purple Parts set complete, device check not
complete on original table
Blue Parts set complete, device check not
complete on table that is not the original
table
Red
White
WhitePurple
Green
Yellow
Blue
Production Table Reservation
Part set complete Device check complete
Table display color
Red
1 – 22Version 5.0
FCP IV-3 Operation
Chapter 4 The DisplayPart 1
The relationships between the displays above are shown in the
Venn diagram below.
If the device check function is not used, the setting of parts can
only be cancelled or completed using the [PARTS SET]
CANCEL/COMPLETE switch.
Refer to Part 2, Chapter 4, Device Check, for details about the
device check function and the parts set cancel/complete
operation.
(c) Special operations procedures display here.
Stop after Current Board After finishing the board
currently being processed the
machine will stop.
Checking Device by HT Device check is currently being
carried out using a Handy
Terminal.
Calculating Placing Data Calculation of data necessary for
placing parts is currently being
carried out.
Vision Processor Executing Waiting for vision processing to
be completed.
(d) Information about optional functions display here.
In the case of Handy Terminal compatible operation, if the next
program has been specified then the name of this program will
display here.
If operating in the HELPS mode then the name of the
announcement or reservation program will display here.
1 – 23Version 5.0
FCP IV-3 Operation
Part 1 Chapter 4 The Display
4.2.2 Display When Not In Automatic Operation
(a) Information about all stations from one to seven is displayed.
ST1.N 1 D 35 Er ***
ST2.N 1 D 35 Er ***
ST3.N 1 D 35 Er ***
ST4.N 1 D 35 Er ***
ST5.N 1 D 35 Er 0
ST6.N 1 D 35 Er 0
ST7.N 1 D 35 Er 0
This is a display of the sequence and device numbers for every
station. “Er ***” means that vision processing has not yet been
completed. The “0” error code indicates that production has
finished under normal conditions. For further information on
error codes, refer to Part 6 of this manual.
Note: In Changeover mode and Device Change mode, when Device
Table 2 (81-160) is the original table, the device positions will
be displayed as 1-80. Note that when the next device is being
used, the machine will display the actual device number, (as
opposed to the device number which has been coded in the
program).
(b) The operation modes are displayed here in the same way they
are during automatic operation.
(c) Information about special operations is displayed here.
Seq. End Stop The machine has finished the board it was
processing when [S_STOP] was pressed.
(d) This display is the same as in the automatic operation display.
1 – 24Version 5.0
FCP IV-3 Operation