00196624-04_Service Manual WPC5_6_EN_01-2019 - 第102页
Service Ma nual W PC5 / WPC6 ➢ Fix the load axis drive motor (see "3.5.2 Replac ing the Load Axis Dri ve Motor" [ ➙ 3-34 ]). ➢ Fit the cover back o n the loading u nit. ➢ Loosen the counternut fastening the sen…
Service Manual WPC5 / WPC6
3.7.13 Sensor 18 NSM module (WPC6) - Tray correctly inserted
Spare Parts
• Sensor tray correctly inserted [03056959-xx]
Removal / Installation
➢
Remove the cover on the load unit (see "3.5.1.1 Removing the Cover on the Load Unit"
[➙ 3-32]).
➢
Remove the load axis drive motor (see "3.5.2 Replacing the Load Axis Drive Motor"
[➙ 3-34]), to gain access to the sensor from below.
Legend
7. Sensor tray correctly inserted.
8. Sensor tray detection load axis.
➢ Disconnect connector X4 from the
circuit board.
Service Manual WPC5 / WPC6
➢ Fix the load axis drive motor (see "3.5.2 Replacing the Load Axis Drive Motor" [➙ 3-34]).
➢ Fit the cover back on the loading unit.
➢ Loosen the counternut fastening
the sensor on the underside of the
base plate and unscrew the sensor
(1).
➢ Screw the new sensor into place.
➢ The sensor should protrude at least
0.2 mm above the table plate.
➢ Use a counternut to fix the sensor
on the underside
(1).
➢ Reconnect connector X4 to the
circuit board.
Service Manual WPC5 / WPC6
3.7.14 Sensor 15 NSM-Modul (WPC6) – Safety flap open
Spare Part
• Sensor safety flap open [03056958-xx]
Removal / Installation
➢ Remove the cover on the load unit (see "3.5.1.1 Remove the Cover on the Load Unit" [➙ 3-
32]).
➢
Loosen the screws marked at 1 to 4
and lift off the cover.
➢ Disconnect connector X3 for the
safety flap when open from the
circuit board.