TM-300_0wners_Manual - 第9页
TM-300 Saf e ty In struc tio ns 61170511. fm Page 3 of 27 W ARNING : Always observe the f ollowin g sa fety g uidelin es whe n oper ating the TM -300 . Do not, un der any circ umst anc e s, remo ve or obstruct a ny warni…
TM-300 Safety Instructions 61170511.fm Page 2 of 27
In this document you will find:
* important safety guidelines to follow when
operating the equipment.
* important definitions of safety markings.
WARNING: Read the provided manuals
thoroughly before attempting to operate
this machine.
Customers who intend to service and maintain
the TM-300 themselves must only have quali-
fied personnel perform those procedures.
Qualified personnel are considered to be
those persons who have the proper technical
training, have experience to work on this
equipment, and are aware of the hazards to
which they will be exposed. The Service Man-
ual is intended to be a supplement to training
(NOT A REPLACEMENT).
ATTENTION: Place the TM-300 on a stable,
flat surface before operating.
The intended use of the TM-300 Taping
Machine is to place Surface Mount compo-
nents into carrier tape. Use of this equipment
in any other fashion may lead to personal
injury.
The safety guidelines provided on the follow-
ing pages are intended to educate the user on
all safety issues in order to operate the TM-
300 in a safe manner.
Pay close attention to these statements as
they contain important information on avoiding
potential hazards to yourself or to the equip-
ment.
Safety Introduction
TM-300 Safety Instructions 61170511.fm Page 3 of 27
WARNING: Always observe the following
safety guidelines when operating the TM-300.
Do not, under any circumstances, remove or
obstruct any warning or instruction labels on
the TM-300.
Attention
This mark is placed on the equipment near the
adjustment, danger, or danger zone.
Dangerous Voltage
Indicates hazards arising from dangerous volt-
age.
High Temperature
Indicates a hot surface.
Open Book
Refer to the manual before performing mainte-
nance on the TM-300.
Crushed Hand
This mark is placed near areas that can cause
personal injury or damage to the equipment if
unsafe practices are used.
Marking Definitions
TM-300 Safety Instructions 61170511.fm Page 4 of 27
Customers who intend to service and maintain
the TM-300 themselves must have only quali-
fied personnel perform those procedures.
Qualified personnel are considered to be
those persons who have the proper technical
training, have experience to work on this
equipment, and are aware of the hazards to
which they will be exposed. The TM-300 pan-
els should never be removed with power
applied to the unit. Refer to the Operator
Manual for instructions before changing
Power Switch settings, changing fuses, or
removing any panels.
Caution should be taken when removing the
sealer from the TM-300. The body of the
sealer can maintain a high temperature long
after shut down. Procedure for removing the
Sealer is as follows:
Turn the POWER switch to the OFF position.
Shut off the air supply to the TM-300.
Dangerous voltage is present. Before servic-
ing:
Turn the POWER switch to the OFF position.
Shut off the air supply to the TM-300.
Disconnect the incoming power cord to the
TM-300.
Dangerous voltage is present. Follow the pro-
cedure below before removing this cover for
service or maintenance:
Turn the POWER switch to the OFF position.
Disconnect the incoming power cord to the
TM-300.
TM-300 Safety Instructions