TRS Advanced WB Intel Issue 02 - 第37页

Issue 2, Nov 14 TRS Advanced Maintenance 37 10. Cable tie the loom in three positions along the existing looms on the MEK base. IMPORTANT : Keep the looms as LOW & FLAT to the base as possible to avoid snagging when …

TRS Advanced Maintenance

Issue 2, Nov 14

7. Tighten all 8 rail cap fasteners equally, as shown below.

8. Blue Loctite 6 off M5x16 clamping block screws, torque to 4.9Nm.

9. Connect 2 rail cap looms previously removed and neat them tightly by using cable ties as

shown below.

NOTE

The loom must sit between the pneumatic pipes and the sensor mount, ensure that the

cable is free to move up and down with the rail cap.

M4x8 Countersunk

Screws

M4x8 Countersunk

Screws

M4x25 Pan Head Screws

(4 Positions)

M4x16 Pan

Head Screws

M4x16 Pan

Head Screws

View on Rail Cap Assembly

Issue 2, Nov 14

TRS Advanced Maintenance

10. Cable tie the loom in three positions along the existing looms on the MEK base.

IMPORTANT: Keep the looms as LOW & FLAT to the base as possible to avoid

snagging when the TRA cross-beam travels fully forward.

TRS Advanced Maintenance

Issue 2, Nov 14

Objective 14: Replacement of the Rail Cap Bearings

• Care should be taking whilst removing the current bearing from the rail cap assembly. Lift

the bearing assembly with the “bearing locating retainer”, damage may occur on the

retainers.

Note

For old design of the rail cap assembly only.

• When fitting the bearings to the rail cap orientate them as shown below:

Bearing Locating

Retainer