TRS Advanced WB Intel Issue 02 - 第54页
TRS Advanced Maintenance 54 Issue 2, Nov 14 43. Adjust the front rail pos ition using equal amounts of feeler gauge as a GO / NOGO, as shown picture below. 44. The rail must be parallel to the buttons with an overall tol…
Issue 2, Nov 14
TRS Advanced Maintenance
53
41. With the pins fitted under the rail cap check that a gap exists between the board clamp /
rail and the MEK reference surfaces across the whole assembly.
42. Push the front rail into contact with the buttons of the Rail Alignment Jig (RAJ).
TRS Advanced Maintenance
54
Issue 2, Nov 14
43. Adjust the front rail position using equal amounts of feeler gauge as a GO / NOGO, as
shown picture below.
44. The rail must be parallel to the buttons with an overall tolerance of 0.05mm.
45. At the same time, adjust the gap between the inside face of the front belt guide and
the front vertical faces of the rail cap to 0.3mm +/-0.05mm.
View on Rear of the Transport Rail and the Rail Cap
Issue 2, Nov 14
TRS Advanced Maintenance
55
46. When adjusted OK, tighten the 2x front center screws as shown below.
47. Tighten the 4 off front locating plates screws through the access holes provided in the
rail cap as shown below. A small flat bladed screwdriver will be required for this.
CAUTION: Do NOT over tighten. Damage can occur to screwdriver / screws.
View on Rail Cap (No RAJ Fitted)
M4x25 Pan
Head Screws
Access Holes
(for M3x8 Screws)
(2 Positions)
Access Holes
(for M3x8 Screws)
(2 Positions)
View on Rail Cap and RAJ