00196602-05_SM_SIPLACE_X-Feeder_EN - 第19页

6 Repairing the X Feeder modules 6.1 Front sliding guide Service Manual SIPLACE X-Feeder 4 - 88 mm 11/2017 19 6 Repairing the X Feeder modules NOTICE Function status The tasks described in this manual apply to X feeder m…

100%1 / 90
5 Diagnosis and Solutions
5.1 Assignment of Symptoms/Repairs
18 Service Manual SIPLACE X-Feeder 4 - 88 mm 11/2017
Rocker
The rocker is bent.
The plain tamp wheel for the rocker has jammed.
The thread of the bearing shaft is worn.
Replace the rocker assembly
The plain tamp wheel for the rocker is worn or dam-
aged.
Replace the plain tamp wheel
The bearing shaft of the rocker is rough-running or
damaged.
The slit in the bearing shaft is damaged.
Replace the rocker bearing shaft.
Control panel
The display window, an LED lamp or a button is de-
fective.
The removal handle is defective or does not engage
properly.
Replace the operating panel assembly
Leaf spring
The leaf spring on the tape inlet is missing or bent. Replace the leaf spring
6 Repairing the X Feeder modules
6.1 Front sliding guide
Service Manual SIPLACE X-Feeder 4 - 88 mm 11/2017 19
6 Repairing the X Feeder modules
NOTICE
Function status
The tasks described in this manual apply to X feeder modules from function state 4 up-
wards. X feeder modules with function state 3 and lower need to be sent to the manufac-
turer for repairs.
NOTICE
Example
All tasks described in this section are illustrated using the 8mm X feeder module as an ex-
ample. Deviations are indicated separately.
CAUTION
Observe the ESD regulations!
Pay attention to feeder module ESD safety:
Before you open the side cover, make sure you are wearing the ESD protection wristband,
to prevent damage to the highly sensitive boards inside the feeder module.
CAUTION
Surface
Always place the feeder module carefully down on a stabile, even and clean surface for re-
pair work.
6.1 Front sliding guide
Required spare parts
Feeder module Item no. Designation
4–88mm 03058808-Sxx Sliding guide
Additional spare part available
Feeder module Item no. Designation
4–88mm 03019604-Sxx Sliding foil, X-feeder JUM-S-06LY
Required tools
●
Sliding foil remover
●
Phillips screwdriver
6 Repairing the X Feeder modules
6.1 Front sliding guide
20 Service Manual SIPLACE X-Feeder 4 - 88 mm 11/2017
6.1.1 Removing the Front Sliding Guide
NOTICE
The pickup window must be fitted
To prevent damage to the sprocket wheel and the reject device, make sure that the pickup
window is fitted for this work.
► Turn the feeder module so that its underside is at
the top.
► Place the sliding foil remover into the sliding
guide, as shown in the diagram.
► Lever the sliding foil out of the engaged position.
► Lever the sliding foil until it has been turned by
approximately90°.
► Push the sliding foil towards the front and out of
the sliding guide.
► Loosen the 2 screws.
► Lift the sliding guide off the feeder module.