00196602-05_SM_SIPLACE_X-Feeder_EN - 第20页
6 Repairing the X Feeder modules 6.1 Front sliding guide 20 Service Manual SIPLACE X-Feeder 4 - 88 mm 11/2017 6.1.1 Removing the Front Sliding Guide NOTICE The pickup window must be fitted To prevent damage to the sprock…
6 Repairing the X Feeder modules
6.1 Front sliding guide
Service Manual SIPLACE X-Feeder 4 - 88 mm 11/2017 19
6 Repairing the X Feeder modules
NOTICE
Function status
The tasks described in this manual apply to X feeder modules from function state 4 up-
wards. X feeder modules with function state 3 and lower need to be sent to the manufac-
turer for repairs.
NOTICE
Example
All tasks described in this section are illustrated using the 8mm X feeder module as an ex-
ample. Deviations are indicated separately.
CAUTION
Observe the ESD regulations!
Pay attention to feeder module ESD safety:
Before you open the side cover, make sure you are wearing the ESD protection wristband,
to prevent damage to the highly sensitive boards inside the feeder module.
CAUTION
Surface
Always place the feeder module carefully down on a stabile, even and clean surface for re-
pair work.
6.1 Front sliding guide
Required spare parts
Feeder module Item no. Designation
4–88mm 03058808-Sxx Sliding guide
Additional spare part available
Feeder module Item no. Designation
4–88mm 03019604-Sxx Sliding foil, X-feeder JUM-S-06LY
Required tools
●
Sliding foil remover
●
Phillips screwdriver
6 Repairing the X Feeder modules
6.1 Front sliding guide
20 Service Manual SIPLACE X-Feeder 4 - 88 mm 11/2017
6.1.1 Removing the Front Sliding Guide
NOTICE
The pickup window must be fitted
To prevent damage to the sprocket wheel and the reject device, make sure that the pickup
window is fitted for this work.
► Turn the feeder module so that its underside is at
the top.
► Place the sliding foil remover into the sliding
guide, as shown in the diagram.
► Lever the sliding foil out of the engaged position.
► Lever the sliding foil until it has been turned by
approximately90°.
► Push the sliding foil towards the front and out of
the sliding guide.
► Loosen the 2 screws.
► Lift the sliding guide off the feeder module.
6 Repairing the X Feeder modules
6.2 Rear Sliding Guide
Service Manual SIPLACE X-Feeder 4 - 88 mm 11/2017 21
6.1.2 Fitting the Front Sliding Guide
NOTICE
The pickup window must be fitted
To prevent damage to the sprocket wheel and the reject device, make sure that the pickup
window is fitted for this work.
► Insert the sliding guide - as shown in the diagram
- into the groove on the drive carrier.
► Position the front sliding guide so that you can
see the holes for the screws through the sliding
guide.
► Fix the sliding guide to the feeder module with
the 2 Phillips head screws (M3x10mm).
► Press the sliding foil slightly together.
► Push the sliding foil from the front into the sliding
guide, until it engages audibly.
6.2 Rear Sliding Guide
Required spare parts
Fig.2: Rear sliding guide L200
Feeder module Item no. Designation
4–88mm 03003994-Sxx Sliding guide/rear L200
Required tools
●
Phillips screwdriver
●
TORX screwdriver size T8