00196602-05_SM_SIPLACE_X-Feeder_EN - 第80页
6 Repairing the X Feeder modules 6.7 Operating Panel Assembly 80 Service Manual SIPLACE X-Feeder 4 - 88 mm 11/2017 ► (1) Insert the flat ribbon cable into the connection, as far as the stop. Make sure that the blue surfa…
6 Repairing the X Feeder modules
6.7 Operating Panel Assembly
Service Manual SIPLACE X-Feeder 4 - 88 mm 11/2017 79
► (1) Push the front part of the control panel as far
as the stop into the slit in the foil container frame.
► (2) Pull the control panel towards the foil con-
tainer.
► (3) Press the release handle into the control
panel.
► Fix the control panel with the self-cutting Torx
screws marked in the diagram.
Run the cable as shown in the example diagram (8
mm feeder module).
► (1) Run the flat ribbon cable vertically downwards
and carefully fold it to the left.
► (2) Carefully fold the flat ribbon cable as marked
in the diagram.
Make sure that the blue surface at the end of the
cable is at the top.
► Thread the other cable under the flat ribbon
cable, to the second connection.
6 Repairing the X Feeder modules
6.7 Operating Panel Assembly
80 Service Manual SIPLACE X-Feeder 4 - 88 mm 11/2017
► (1) Insert the flat ribbon cable into the connection,
as far as the stop.
Make sure that the blue surface at the end of the
cable is at the top and that the flat ribbon cable
lies straight in the connection.
► Swing the lock on the connection down onto the
flat ribbon cable.
Make sure that the flat ribbon cable is fitted firmly
in the connection. Tug gently on the cable to
check.
► Check again whether the flat ribbon cable is fitted
straight in the connection.
If necessary, open the lock and correct the posi-
tion of the cable before closing the lock again.
► (2) Carefully insert the connector in the direction
of the arrow, as far as the stop, into the connec-
tion shown.
Make sure that the smooth side of the connector
is at the top.
CAUTION!
Do not push the connector with force into the
connection, otherwise individual pins may
break off or be distorted.
.
► Fit the left side cover into place (see 6.3.2 "Fitting
the Left Side Cover" [}24]).
► Carefully place the feeder module down on its left
side.
► Fasten the 2 self-cutting Torx screws marked in
the diagram.
6 Repairing the X Feeder modules
6.7 Operating Panel Assembly
Service Manual SIPLACE X-Feeder 4 - 88 mm 11/2017 81
6.7.5 Removing the Operating Panel (16 - 88 mm)
► Carefully place the feeder module down on its left side.
► Remove the screws shown in the following diagram.
Example diagram for X feeder modules with 16mm
width
Example diagram for X feeder modules with 24 -
88mm width
► Now carefully place the feeder module down on its right-hand side.
► Remove the left side cover (see 6.3.1 "Removing the Left Side Cover" [}23]).
► (1) Pull the connector marked in the diagram up
and out of its connection.
To loosen the connector, move it carefully from
side to side.
► (2) Pull the connector marked in the diagram out
of its connection in the direction of the arrow. Pull
on the connector and NOT on the cable.
► (3) Carefully swing the lock on the flat ribbon
cable connection up to the left and release the
flat ribbon cable.
Make sure that the lock is not pushed too far
back. It could break off if you do this.
► Pull the connector shown in the diagram out of its
connection in the direction of the arrow. Pull on
the connector and NOT on the cable.