2.VGOS V30 application software installation_upgrade manual - 第7页

For Users Serv i ce Information SI090100 2E- 003=VGOS V3 0 applicatio n software installatio n /upgrade manua l 7/24 Step 3 Click the [OK] but ton to start copying the image. Note If the previously installed image is in …

For Users

Service Information

SI0901002E-003=VGOS V30 application software installation/upgrade manual

6/24

2.2 Copy install/upgrade image to the USB flash drive

You can copy the install/upgrade image from the CD to an USB flash drive by using the

“Image Copy” program in the CD.

Step 1 Prepare the PC. Insert the USB flash drive into the USB port and the

installation/upgrade CD into the CD drive. The “Image Copy” program starts

automatically.

Depending on the PC setting, the Image Copy program may not start automatically.

Note

In the Image Copy program does not start automatically, select “VgosImageCopy.exe” in

the “Image Copy” folder in the CD to start the program.

Step 2 Check the drives for copying the install/upgrade image.

The following dialog box appears when the Image Copy program starts. Check if the correct

drives are selected for the [Source Drive] and [Destination Drive].

Note

If the USB flash drive is not inserted into the USB port or not recognized properly, the [OK]

button is grayed out as shown in the below right figure. Make sure to insert the USB flash

drive into the USB port properly.

For Users

Service Information

SI0901002E-003=VGOS V30 application software installation/upgrade manual

7/24

Step 3 Click the [OK] button to start copying the image.

Note

If the previously installed image is in the USB flash drive, the following message box

appears. If you click the [Yes] button, the existing image is deleted and the new image is

copied onto the USB flash drive. If you click the [No] button, the copying process is

interrupted.

Note

If the USB flash drive has no enough available space, the following message box appears

and the copying process is interrupted. In this case, delete unneccesary files in the USB

flash drive and restart from step 1.

Step 4 Complete the copying process.

When the copying process is completed, the following message box appears. Click the [OK]

button to close the application and remove the USB flash drive from the PC.

For Users

Service Information

SI0901002E-003=VGOS V30 application software installation/upgrade manual

8/24

3 Initial installation of the application software

When you install the system software on a blank CompactFlash (“CF”), install the application

software on the machine as shown below.

Step 1 Install the CF with the system software installed onto the machine.

Set the CF on the system board. Then set the system board in the control box of the

machine.

Note

For information about the CF replacement, see “SI1108004E: YS series, YG12, YG300

system board replacement”.

Step 2 Make sure the machine is in safe operating condition. Power on the machine.

Step 3 Set the installation/upgrade CD or USB flash drive to the machine.

n USB flash drive

Set the USB flash drive prepared in “2.2 Copy install/upgrade image to the USB flash drive”

on page 6 into the USB port of the machine.

n CD

Set the installation/upgrade CD into the CD drive of the machine. The CD drive is below the

operation panel of the machine front side.

Step 4 Start the VGOS Application Version Up program.

From Windows start menu, select [Programs], [Vg Machine] then [VersionUp] to run the

program.

Note

When the system version is V3.00, or when other USB flash drive than the designated one

is used for application installation/upgrading, the VGOS Application Version Up program is

not selectable via the above menu selection. Start the explorer and double click “Setup.exe”

in the installation image instead.