2.VGOS V30 application software installation_upgrade manual - 第8页

For Users Serv i ce Information SI090100 2E- 003=VGOS V3 0 applicatio n software installatio n /upgrade manua l 8/24 3 Initial i nst al lation of the ap pli cation sof tw are W hen you i nsta ll the system software on a …

For Users

Service Information

SI0901002E-003=VGOS V30 application software installation/upgrade manual

7/24

Step 3 Click the [OK] button to start copying the image.

Note

If the previously installed image is in the USB flash drive, the following message box

appears. If you click the [Yes] button, the existing image is deleted and the new image is

copied onto the USB flash drive. If you click the [No] button, the copying process is

interrupted.

Note

If the USB flash drive has no enough available space, the following message box appears

and the copying process is interrupted. In this case, delete unneccesary files in the USB

flash drive and restart from step 1.

Step 4 Complete the copying process.

When the copying process is completed, the following message box appears. Click the [OK]

button to close the application and remove the USB flash drive from the PC.

For Users

Service Information

SI0901002E-003=VGOS V30 application software installation/upgrade manual

8/24

3 Initial installation of the application software

When you install the system software on a blank CompactFlash (“CF”), install the application

software on the machine as shown below.

Step 1 Install the CF with the system software installed onto the machine.

Set the CF on the system board. Then set the system board in the control box of the

machine.

Note

For information about the CF replacement, see “SI1108004E: YS series, YG12, YG300

system board replacement”.

Step 2 Make sure the machine is in safe operating condition. Power on the machine.

Step 3 Set the installation/upgrade CD or USB flash drive to the machine.

n USB flash drive

Set the USB flash drive prepared in “2.2 Copy install/upgrade image to the USB flash drive”

on page 6 into the USB port of the machine.

n CD

Set the installation/upgrade CD into the CD drive of the machine. The CD drive is below the

operation panel of the machine front side.

Step 4 Start the VGOS Application Version Up program.

From Windows start menu, select [Programs], [Vg Machine] then [VersionUp] to run the

program.

Note

When the system version is V3.00, or when other USB flash drive than the designated one

is used for application installation/upgrading, the VGOS Application Version Up program is

not selectable via the above menu selection. Start the explorer and double click “Setup.exe”

in the installation image instead.

For Users

Service Information

SI0901002E-003=VGOS V30 application software installation/upgrade manual

9/24

Step 5 Select an install media (source drive) and click the [Install] button.

If the machine is equipped with the CD drive, the “CD Drive” radio button is selectable.

Note

If the specified drive cannot be found, the following warning message appears. Check if the

source USB flash drive or CD is inserted properly, and click the [Install] button again.

Step 6 Select a language for setup procedure.

n Machine Not equipped with CD drive

n Machine equipped with CD drive

(YG300)