00197961-01_UM_JTF-MW_on_SIPLACE_E_en_FINAL - 第56页
Maintenance 56 User Manual JTF-MW on SIPLACE E
Maintenance
User Manual JTF-MW on SIPLACE E 55
6
6 Maintenance
Maintenance
All bearings used in the machine are sealed, and do not require lubrication. The feeder uses dry-run
chains, and these should not be lubricated.
At the end of every shift:
► Clean the feeder.
► Remove components that might have been dropped on the JTF-MW.
Maintenance
56 User Manual JTF-MW on SIPLACE E
Service Work
7.1.1 LED Status on the Control Board Troubleshooting
User Manual JTF-MW on SIPLACE E 57
7
7 Service Work
Service Work
7.1
7.1 Troubleshooting
Troubleshooting
7.1.1
7.1.1 LED Status on the Control Board
LED Status on the Control Board
All sensors and buttons are monitored on the LED bars on the controller PCB.
This is a help to determine errors on the feeder.
Location and function of the senor LEDs
Controller PCB
Sensor LED Function
LED 1 Gap sensor
LED 3 Forward slow down sensor
LED 4 Stop at end
LED 5 Tray position
LED 6 Reset button
LED 7 Stop button
LED 9 Inhibit button
LED10 Elevator down button
LED 12 Tray Home sensor
LED 13 Reverse slow down sensor
LED 14 Elevator high position limit
LED 15 Elevator low position limit
LED 16 Door open
LED 17 Index 1 AND 2