00192156-04 - 第52页
Maintenance Maintenance Instr uctions F 8 2-monthly maintenance work 03/2003 US E dition 52 8
Maintenance Instructions F Maintenance
03/2003 US Edition 8 2-monthly maintenance work
51
Inspect or replace the silencer for the Pick & Place head 8
a Turn the silencer for the Pick & Place head counterclockwise to remove.
s Remove the filter from the casing and check for dirt.
: Replace the entire vacuum generator for the Pick&Place head, if the filter is dirty.
Make sure that the plastic thread of the silencer is straight. 8
8
8
Clean and grease the toothed belts for the X, Y and Z axes 8
: Clean the toothed belts for the X, Y and Z axes.
8
d Grease the toothed belt for the Y axis using a short-bristled brush dipped in ISOFLEX TOPAS
NCA 52.
f Grease the toothed belt for the X axis using a short-bristled brush dipped in ISOFLEX TOPAS
NCA 52.
g Grease the toothed belt for the Z axis using a short-bristled brush dipped in ISOFLEX TOPAS
NCA 52.
: Move the axes backward and forward to distribute the grease evenly over the toothed belts.
8
8
8
8
8
8
8
8
8
Maintenance Maintenance Instructions F
8 2-monthly maintenance work 03/2003 US Edition
52
8
Maintenance Instructions F Maintenance
03/2003 US Edition 8 2-monthly maintenance work
53
Maintain the component feeder table 8
a Clear the feeder area.
: Remove any loose components from the component feeder table using the vacuum cleaner.
s Use a whetstone to remove any irregularities from the magnetic bar.
8
8
d Preserve the feeder area using a lint-free cloth sprayed with WD40.
f Vacuum up any loose components from the tape container and remove any unwanted stickers
and adhesive tape.
8
g Cut off the excess used tape flush with the feeder and empty the component drawer on 8 mm
S feeders.
: Return the feeders to the feeder area.
Make sure that each feeder is in the correct location and is connected correctly. 8
8
8
8
8
8
8