00196624-04_Service Manual WPC5_6_EN_01-2019 - 第109页
Service Manua l WPC5 / WPC6 Page 3-109 Removal / Install ation The s ensor for t he saf ety fl ap whe n ope n is l oca ted on t he und ersid e of t he base plate . See also … . @ 3.5 .1. 4 Loosen the Tens ion of the Lo…
Service Manual WPC5 / WPC6
Page 3-108
3.7.17 Sensor 16 NSM module (WPC6) – Safety Sensor for the Hand Guard
Spare Part
• Safety sensor hand guard [03056990-xx]
Preparations
Loosening the belt tension
➢ Loosen the tension of the load axis
drive belt (2) at the tensioning
screw behind the tower (1).
Removing the base plate
➢ Loosen the screws fixing the motor
to the base plate at (3).
➢ Lift off the base plate and turn it
over.
Service Manual WPC5 / WPC6
Page 3-109
Removal / Installation
The sensor for the safety flap when open is located on the underside of the base plate.
See also….
@
3.5.1.4
Loosen the Tension of the Load Axis Drive Belt [➙ 3-33]
@
3.5.6
Setting the Load Axis Belt Tension [
➙
3-43]
➢ Disconnect connector X7 for the
safety flap when open from the
circuit board.
➢ Remove the two screws fastening
the sensor (1).
➢ Insert the new sensor and fix into
place with the two screws.
➢ Reconnect connector X7 to the
circuit board.
Service Manual WPC5 / WPC6
Page 3-110
3.7.18 Lading flap close magnet
Spare Parts
• Lading flap close magnet [03083123-xx]
Removal / Installation
The holding magnet is mounted on a pedestal (1) in the NSM panel with 3 "NB602 M4x8"
screws [03005643].
The 3 screws can be accessed from the outside through a hole in the underside of the panel
(2).
The magnet has a 20 cm long cable with a 2 pin plug firmly attached.
The magnet is plugged into connector X30a on the back of the "backplane control
module" via the "cable: holding magnet loading flap" [03083109-01].
The adjustment with respect to the distance of the magnet to the loading door via the
"magnetic plate", which is mounted on the tailgate.
1
2
Attention: Do not clamp the cable!
Lead the cable through the notch on
the magnet.