182049 Viking Installation Manual - 第23页
semi automatic UNPACKING INSTRUCTIONS INTRODUCTION Chapter Issue 1 Oct 02 Instal lation Manual 4.3 Inventory Using t he Sales Acknowledgment she et check the machine against the cus- tomer machin e configuration - Machin…
semi automatic
UNPACKING INSTRUCTIONS
INTRODUCTION
4.2 Installation Manual Chapter Issue 1 Oct 02
Miscellaneous
Items
Ensure the following additional equipment is complete and correct:
Documentation Ensure the following machine documentation is complete and correct:
Item Yes No
Calibration Screen
Calibration Board
Alignment Test Board
Board Clamp Setting Plate
Paste Deflectors, set of 2 (4 items total)
Rail to Table Height Setting Plates (2 items)
Spares Kit (if ordered)
DEK Semi Automatic Software / DEK Semi Automatic Recovery CD-ROM
Item Yes No
DEK Semi Automatic Technical Manuals CD-ROM incorporating:
• Operator Manuals (in all available languages)
• Technical Reference Manual
• User Manual
• Installation Manual
• Electrical Drawings
• Mechanical Drawings
Installation Manual (paper)
Operator Manual (Paper)
Solvent Data Sheet (optional)
Configuration & Dispatch Procedures
Alignment Data
CE Certificate
DEK Delivery Questionnaire
semi automatic
UNPACKING INSTRUCTIONS
INTRODUCTION
Chapter Issue 1 Oct 02 Installation Manual 4.3
Inventory Using the Sales Acknowledgment sheet check the machine against the cus-
tomer machine configuration - Machine Components, Miscellaneous Items and
Documentation as listed.
If any components or items are missing or faulty, make a note of this on the
Outstanding Issues page found in the Installation Documentation chapter of this
manual.
Inspection Visually inspect all machine components and equipment for completeness,
condition and damage.
If any components or equipment are incomplete, damaged or in poor condition,
make a note of this on the Outstanding Issues page found in the Installation
Documentation chapter of this manual.
semi automatic
UNPACKING INSTRUCTIONS
TRANSPORTATION
4.4 Installation Manual Chapter Issue 1 Oct 02
TRANSPORTATION
WARNING
MACHINE LIFTING. TO PREVENT SERIOUS INJURY TO PERSONNEL, DURING
LIFTING AND TRANSPORTATION OPERATIONS, ENSURE THE MACHINE IS
LIFTED AND TRANSPORTED IN ACCORDANCE WITH INSTRUCTIONS
DETAILED IN THIS SECTION.
CAUTION
MACHINE DAMAGE.
Damage to the machine may occur if the machine is
lifted incorrectly.
1. Do not raise the machine using lifting strops.
2. Do not lift the machine from the sides.
Remove the four nuts and washers securing the machine to the transportation
box base using a 36mm spanner (wrench).
The machine may be lifted using a fork lift truck or similar machine that meets
the following criteria:
• Minimum fork length of 54" (1372mm)
• 27"min (686mm) / 54"max (914mm) fork span
• Lifting capability of 2000kg
1. Locate the forks under the machine base (preferably from the rear) so the
weight of the machine is taken evenly on the front and rear cross members
(Machine on Fork Lift Truck figure refers).
2. Fit the four mounting feet, as detailed in the figure below. Adjust the height
of each foot to approximately the same height, secure in place by tightening
the nuts.
Figure 4-1 Mounting Feet Arrangement