TDS_Sonix_355_CRRD_ENG.pdf - 第2页

Sonix ® 355 CRRD TECHNICAL DATA SHEET 2 www.dct.cleaning GENERAL INFORMATION Depending on your cleaning requirements, the DCT project manager, in collaboration with a local distributor, will advise you on a suitable wate…

100%1 / 8
Conformal coating removing
PCB cleaning
www.dct.cleaning
www.dct.cleaning
Sonix
®
355 CRRD
www.dct.cleaning
TECHNICAL DATA SHEET
CHAMBER
Sonix
®
355 CRRD 
TECHNICAL DATA SHEET
2
www.dct.cleaning
GENERAL INFORMATION
Depending on your cleaning requirements,
the DCT project manager, in collaboration
with a local distributor, will advise you
on a suitable water-based cleaning fl uid
and the correct setup of the entire process.
The Sonix® cleaning systems are a unique ultrasonic
technology developed and manufactured by DCT.
In the past, machines with ultrasonic technology were
used for PCBA, which is no longer used or recommended
due to component sensitivity, miniaturization, higher
rinsing quality requirements, etc.
We recommend Sonix® cleaning systems mainly
for special cleaning applications to eff ectively
remove cured conformal coating.
Exceptionally, they can be used for board cleaning
if the boards are compatible with ultrasonic technology.
They are also suitable for degreasing processes
of metal components.
It can also be used for “dual” application – one chamber
for cleaning of coating frame and pallets, second for
cleaning of re ow oven and wave soldering machine parts.
Sonix
®
355 CRRD including 100% separated
processes of cleaning, pre-rinsing,  nal rinsing and drying
technologies.
All processes are automated and take place in
4 separate process chambers, which are also storage
tanks.
Cleaning takes place in the  rst inlet chamber, where the
operator places the basket with parts. Then the operator
manually moves the basket with the cleaned parts into the
secondary pre-rinse chamber. The operator then moves
the basket to the  nal rinse chamber and  nally to the last
drying chamber.
All 4 chambers can be used in parallel, which
increases the machine’s cleaning capacity, reduces
cross-contamination when compared with single-chamber
devices and optimizes rinsing with two rinsing chambers.
Sonix
®
355 CRRD is designed to remove cured conformal
coatings from coating frames, coating machine parts or
coated PCBs for repair and subsequent coating.
In certain cases, Sonix
®
355 CRRD may also be
recommended for PCB cleaning or for degreasing
of metal components.
Sonix
®
355 CRRD 
TECHNICAL DATA SHEET
3
www.dct.cleaning
C
R
R
D
Application
name
Recommended
application
Recommended
temperature
Total cleaning
process time
Capacity
per 8 hours
Conformal coating removing
40 – 55°C 104 – 131 °F 60 min. 960 * / 80 *
PCB
35 – 55°C 95 – 131 °F 35 min. 1440 **
4 INDIVIDUAL PROCESSES
CLEANING PARAMETRES
C
CLEANING
PRE-RINSING
RINSING
DRYING
R
D
R
highly recommended recommended applicable
* PCB eurocards / per 8 hours (calculated for dimension of 100 x 160 mm / 3.94 x 6.3 in)
* * Parts in soldering palette / per 8 hours (320 x 500 x 50 mm / 12,6 x 19,7 x 1,97 in)
* * * Stencils, pumpprints larger than 736 x 736 mm / 29 x 29 in
LEGEND: