SPS Configuration SX1 - 2-Version-2.pdf - 第18页
THA NK Y OU Name: M ath ias M ichel Departmen t: A SM AS CRM CS P M &E Address: P hone: M ail: mathias.m iche l@ as mpt .co m
20.04.2017 Page 16
Configuration SPS for SX2 with WPC
Location 1/2
Table position outer
Only with this configuration an
SPS magazine is required on
location 2 in combination with
stat. camera SST33!
Support plate for location 2
necessary!
Gantry 1
SST33
FCU
Sensor
Sensor
WPC
5/6
FC/3D
FCU
Sensor
Sensor
Sensor
Gantry 2
Gantry 1
SST33
FCU
Sensor
Sensor
WPC
5/6
ST33
FCU
Sensor
Sensor
WPC
5/6
FC/3D
Gantry 2
Location 1/2
Table position outer
SPS magazine Q10 on NC position 4
SST33
20.04.2017 Page 17
Calibration and Test Smart Pin Support
Calibration steps: 13. Offset Pin picker -> PCB camera
14. Position check on the lifting table
15. Calibrate magazine position
Endurance test for
SPS Head
THANK YOU
Name: Mathias Michel
Department: ASM AS CRM CS PM&E
Address:
Phone:
Mail: mathias.michel@asmpt.com