TDS_InJet_388_TWIN_CRD_ENG.pdf - 第2页

InJet ® 388 TWIN CRD TECHNICAL DATA SHEET 2 www.dct.cleaning GENERAL INFORMATION The InJet 388 series cleaning systems represent unique vertical Spray-In-Air technology developed and manufactured by DCT. The vertically i…

100%1 / 8
STENCIL, MISPRINT, SQUEEGEE cleaning
PUMPRINT cleaning
PCB cleaning
www.dct.cleaning
TECHNICAL DATA SHEET
InJet
®
388 TWIN CRD
Sausage dog
www.dct.cleaning
CHAMBER
STENCIL, MISPRINT, SQUEEGEE
cleaning
PUMPRINT
cleaning
InJet
®
388 TWIN CRD
TECHNICAL DATA SHEET
2
www.dct.cleaning
GENERAL INFORMATION
The InJet 388 series cleaning systems represent
unique vertical Spray-In-Air technology developed
and manufactured by DCT.
The vertically installed Spray-In-Air device minimizes the
shadowing eff ect commonly seen in horizontal cleaners,
and maximizes the effi ciency of the cleaning process as
the cleaning  uid is sprayed directly onto the cleaned
component.
The InJet
®
388 TWIN CRD, including a 100% closed loop,
with cleaning, rinsing and drying technology processes.
All of the processes are fully automated and take place
in 2 process chambers, whereby the cleaning takes place
in the  rst inlet chamber, after which the part which is being
cleaned is automatically transported via a central transfer
area to the 2
nd
process chamber, where the rinsing
and drying takes place. This chamber is also the outlet
chamber. Both chambers can be used in parallel, which
increases the machine’s capacity and reduces
cross-contamination when compared with single-chamber
devices.
The InJet
®
388 TWIN CRD is developed primarily for the
removal of solder pastes and SMT adhesives from stencils,
PumPrints, squeegees and misprints.
The cleaning system can also be used for PCBA, or for
acombination of board cleaning and the afore-mentioned
cleaning processes.
Both chambers can be used in parallel, thereby increasing
capacity.
Depending on your cleaning requirements,
the DCT project manager, in collaboration
with a local distributor, will advise you
on a suitable water-based cleaning fl uid
and the correct setup of the entire process.
InJet
®
388 TWIN CRD
TECHNICAL DATA SHEET
3
www.dct.cleaning
C
R
C
CLEANING
RINSING
DRYING
R
D
Application
name
Recommended
application
Recommended
temperature
Total cleaning
process time
Capacity
per 8 hours
Stencil, misprint, squeegee
20 – 40°C 68 – 104 °F 18 min. 48
PumPrint
40 – 55°C 104 – 131 °F 18 min. 48
PCB
35 – 55°C 95 – 131 °F 30 min. 768 *
3 INDIVIDUAL PROCESSES
CLEANING PARAMETRES
highly recommended recommended applicable
* PCB eurocards / per 8 hours (calculated for dimension of 100 x 160 mm / 3.94 x 6.3 in)
* * Parts in soldering palette / per 8 hours (320 x 500 x 50 mm / 12,6 x 19,7 x 1,97 in)
* * * Stencils, pumpprints larger than 736 x 736 mm / 29 x 29 in
LEGEND: