TK26714.PickHeightTeaching.pdf - 第2页

 SMT Software Engineering Group  IM Operations Y AMAHA MOTOR CO., L TD  MDOC-SOFT50389   2/18  1. Machine T ype and Sof tware V ersion This function is supported for the following machin e type and software versio…

100%1 / 18
SMT Software Engineering Group
IM Operations YAMAHA MOTOR CO., LTD
MDOC-SOFT50389
1/18
Pick Height Teaching
Contents
Pick Height Teaching....................................................................................................................................................1
Contents..............................................................................................................................................................................1
1. Machine Type and Software Version..............................................................................................................2
2. Overview........................................................................................................................................................................3
2.1 Target.......................................................................................................................................................................3
3. Function Details.........................................................................................................................................................4
3.1 Using Method......................................................................................................................................................4
3.2 Pick Height Take Over Function................................................................................................................6
3.3 Error Message.....................................................................................................................................................7
4. Setting Method.........................................................................................................................................................10
4.1 Machine Setting................................................................................................................................................10
4.2 Takeover of Parts Data.................................................................................................................................13
4.3 Reading fixed board data............................................................................................................................14
5. Limitations...................................................................................................................................................................15
6. Suggestions at upgrading software...............................................................................................................16
6.1. Mark data setting for guide recognition..............................................................................................16
Rev Version Chapter Contents
00 V4.48STD R1.000 ALL Created
01 V4.50STD R1.000
V3.45STD R1.000
2.1
3
3.3
4.3
Fixed board has been supported. (▲1)
本文書に含まれる技術内容は当社の秘密情報です。当社の許諾無く第三者への開示はできません。
The information contained in this message may be confidential and legally protected under
applicable law. The message is intended solely for the addressee(s).
If you are not the intended recipient, you are hereby notified that any use, forwarding,
dissemination, or reproduction of this message is strictly prohibited and maybe unlawful.
SMT Software Engineering Group
IM Operations YAMAHA MOTOR CO., LTD
MDOC-SOFT50389
2/18
1. Machine Type and Software Version
This function is supported for the following machine type and software version.
Table 1.1 Machine Type and Software Version
Machine・Software Version Note
YSM40, YSM20 V4.48STD R1.000 or later
YS100, YS12 series
YS24(X) series
V3.45STD R1.000 or later
SMT Software Engineering Group
IM Operations YAMAHA MOTOR CO., LTD
MDOC-SOFT50389
3/18
2. Overview
This function measures pick height properly by checking vacuum level at moving the head to
the tape guide of a feeder.
To determine pick height, it used to be necessary to measure the tape thickness by caliper,
and to adjust the height considering pick up rate. With this function, pick height is
automatically measured properly, so that you don’t need to create height data before the first
use of the machine.
2.1 Target
1. Supported feeder types are “4mm feeder” and “8mm feeder”.
Feeder parts of 12mm or wider, and tray parts are not supported.
2. Supported feeder guide types are iron and carbon.
Therefore, when one machine has both of above types of tape guides, guide
recognition is necessary to distinguish iron and carbon.
(▲1)
3. Supported nozzle types are as follows.
Table 2.1 Nozzle Type
30X 31X 50X 51X 60X Note
301 311 501 511 601
302 312 502 512 602
313 513
303 314 503 514 603 Carbon tape guide cannot be measured.
309
3010
310
3110
510 On a YS series mounter, 310 nozzle needs
to be set as a special nozzle.
3010 and 3110 nozzles are available only
on YSM20.