TDS_InJet_388_TWIN_CRRD_ENG.pdf - 第2页

InJet ® 388 TWIN CRRD Sausage dog TECHNICAL DATA SHEET 2 www.dct.cleaning GENERAL INFORMATION The InJet 388 series cleaning systems represent unique vertical Spray-In-Air technology developed and manufactured by DCT. The…

100%1 / 8
www.dct.cleaning
TECHNICAL DATA SHEET
InJet
®
388 TWIN CRRD
Sausage dog
www.dct.cleaning
CHAMBER
CHAMBER
STENCIL, MISPRINT, SQUEEGEE cleaning
PUMPRINT cleaning
PCB cleaning
InJet
®
388 TWIN CRRD  Sausage dog
TECHNICAL DATA SHEET
2
www.dct.cleaning
GENERAL INFORMATION
The InJet 388 series cleaning systems represent
unique vertical Spray-In-Air technology developed
and manufactured by DCT.
The vertically installed Spray-In-Air device minimizes the
shadowing eff ect commonly seen in horizontal cleaners,
and maximizes the effi ciency of the cleaning process as
the cleaning  uid is sprayed directly onto the cleaned
component.
The InJet
®
388 TWIN CRRD “Sausage dog” including 100%
closed loop with processes of cleaning, pre-rinsing,  nal
rinsing, and drying technologies. All of the processes are
fully automated, and take place in 3 process chambers.
Cleaning takes place in the  rst inlet chamber, after which
the cleaned part is automatically transported to the central
passage chamber where the  rst rinsing process takes
place. The third, and last, outlet chamber is designed for
the  nal rinsing and the drying process.
Both chambers (inlet and outlet) can be used
simultaneously, which increases system capacity and
reduces cross-contamination compared to single-chamber
systems.
The InJet
®
388 TWIN CRRD “Sausage dog” is developed
primarily for high-capacity and precision PCBA.
The cleaning system can also be used for the high-capacity
removal of solder pastes and SMT adhesives from stencils,
PumPrints, squeegees and misprints.
Depending on your cleaning requirements,
the DCT project manager, in collaboration
with a local distributor, will advise you
on a suitable water-based cleaning fl uid
and the correct setup of the entire process.
InJet
®
388 TWIN CRRD  Sausage dog
TECHNICAL DATA SHEET
3
www.dct.cleaning
C
R
R
Application
name
Recommended
application
Recommended
temperature
Total cleaning
process time
Capacity
per 8 hours
Stencil, misprint, squeegee
20 – 40°C 68 – 104 °F 18 min. 48
PumPrint
40 – 55°C 104 – 131 °F 18 min. 48
PCB
35 – 55°C 95 – 131 °F 30 min. 768 *
4 INDIVIDUAL PROCESSES
CLEANING PARAMETRES
C
R
D
R
CLEANING
PRE–RINSING
RINSING
DRYING
highly recommended recommended applicable
* PCB eurocards / per 8 hours (calculated for dimension of 100 x 160 mm / 3.94 x 6.3 in)
* * Parts in soldering palette / per 8 hours (320 x 500 x 50 mm / 12,6 x 19,7 x 1,97 in)
* * * Stencils, pumpprints larger than 736 x 736 mm / 29 x 29 in
LEGEND: