00194387-02.pdf - 第13页
Third tape reel adapter for component tro lley R22 Retrofit in structions for third tape reel adapter for component trolley R2, HF series / D3 06/2006 Edition 13 2 Retrofit instructions for third t ape reel adapter for c…
1 Nachrüstanleitung Adapter Dritte Gurtrolle BE-Wagen R2 HF-Serie / D3 Adapter Dritte Gurtrolle BE-Wagen R2
Ausgabe 06/2005
12
1.4.4 SMEMA 900 (mit Spleissstellenerkennung)
Der Adapter wird an den jeweiligen hinteren beiden Bohrungen montiert: 1
1
Es können Gurtrollen bis zu einem Durchmesser von 17 Zoll verwendet werden. 1
1.5 Abschliessende Arbeiten
: Rüsten Sie den BE-Wagen mit Gurtrollen auf.
: Docken Sie den BE-Wagen an den Bestückautomaten an.
1
1
Third tape reel adapter for component trolley R22 Retrofit instructions for third tape reel adapter for component trolley R2, HF series / D3
06/2006 Edition
13
2 Retrofit instructions for third tape
reel adapter for component trolley
R2, HF series / D3
2.1 Parts required
2.1.1 Retrofit kit (item no.:00119643-0102)
2
Fig. 2.11 - 1 Third tape reel adapter module
2.1.2 Tools and consumables required
– Set of hexagon socket spanners
Inserting comb
Fixing bracket
2 Retrofit instructions for third tape reel adapter for component trolley R2, HF series / D3 Third tape reel adapter for component trolley
R2
06/2006 Edition
14
2.2 Safety instructions
WARNING
The safety instructions from the “Operational safety” chapter of the user manual and servicing in-
structions take precedence over these instructions. 2
The SIPLACE placement machines are supplied with mains voltage.
Consequently parts of these systems carry dangerous voltages! This voltage is present at certain
modules inside the machine base, even when the machine is switched off at the main power
switch.
Incorrect handling of the placement machine or touching live parts of the machine can result in
death or severe injury, and considerable damage to equipment.
BEFORE starting any work, shut down the operating system correctly, then switch the machine
OFF at the main power switch and disconnect from the main power supply. In addition, the com-
pressed air supply must be switched off at the compressed air unit's main valve in the machine
base and vented by actuating the needle valve on the compressed air unit.
There is DANGER for heart pacemaker wearers in the vicinity of the linear motors, as described
in detail in the "Special safety instructions for working in the vicinity of strong magnetic fields"
section of the user manual and service manual.
Always follow the accident prevention regulations, DIN or other standards and special safety
rules applicable in your country.
Pay attention to the information concerning residual voltages in the Operational Safety chapter.
Follow the ESD regulations as described in the operational safety section of the operating
instructions.
During the retrofit, always secure the machine to prevent access by other people and to prevent
it being switched on again. The procedure is described in the “Locking the machine…” section of
the user manual.
Working with the SITEST program further increases the risk of accident.
The SITEST program must only be used by authorized and trained personnel.
2
2
2