00197790-01.pdf - 第9页
Installation Guide Ausgabe 08/2014 Edition 9 2 Installation 2.1 LED-Carriers mount the LED-c arriers to the m achine cover with the M3x 10 flathead screw s and pol y stop nuts. (drilling diam eter 3.8mm) (ATTENT ION: P…
Installation Guide Ausgabe 08/2014 Edition
8
► Turn the machine on. Make sure that authorized staff check the equipment in operation to
ensure that repairs were performed correctly.
Testing
Service personnel may test circuits by energizing them briefly without suspending the Lock Out /
Tag Out Procedure. This may only be done when no other work is being performed by any other
person on the equipment being tested.
It is extremely important that all remote START switches be tagged with the "Do Not Operate" tag
to prevent inadvertent operation of the equipment during these periods.
Responsibilities
It shall be the responsibility of the maintenance and service personnel to make sure this
procedure is adhered to.
It shall be the responsibility of the maintenance and service personnel's immediate supervisor
to instruct his personnel on this procedure.
It shall be the responsibility of the Safety Officer with assistance from the Safety Committee,
Health Service Department, and the various managers and vice-presidents to administer the
Lock Out / Tag Out Procedure.
1.3 Scope of delivery
retrofitted central machine cover
2 LED-carriers with each 70 1W high power LEDs
Power supply 12V
2 auxillary switches
3 passing clamps grey
1 passing clamp blue
cables
11 Cable ties small
3 Cable ties medium
12 Cable tie base
Screws
Installation Guide Ausgabe 08/2014 Edition
9
2 Installation
2.1 LED-Carriers
mount the LED-carriers to the machine cover with the M3x10 flathead screws and poly stop
nuts. (drilling diameter 3.8mm)
(ATTENTION: Please consider the correct polarity 1 = + or brown = +)
stick the cable sockets to the machine cover
Installation Guide Ausgabe 08/2014 Edition
10
Mount the cable 03102816-01 to the cable sockets with cable ties
connect the cable 03102817-01 to the LED-carrier
(ATTENTION: Please consider the correct polarity)