Dek印刷机中文培训.pdf - 第5页
3 Please make sure the Under scr een cleaner at the Fr ont Home position. If not, I will have an Scr een Cleaner out of position Alarm 要把擦网纸 的部分拉到最前面原点的位置ｏ不然就会出擦网纸超出位置 3 T ake out all T able’ s tooling support pins. 先把所有…
3. PCB Clamping & System Switch 夹板刀和开机按纽
PCB clamping is very SHAPE(0.1mm Thickness). Please take care.
夹板刀十分锋利(0.1mm 厚)！请小心
4. Left & Right Toggle Button 左右两按纽控制
Left & Right Toggle Button are using in Diagnostic Mode.
左右两按纽控制在诊断模式用
5. Power up machine.开机的次序
3 Check Air Pressure. Normal is 0.5Bar – 0.6Bara. If Lower than 0.3Bar
will have pressure too low alarm.检查气压,正常在 0.5Bar 至 0.6 Bar.
如果少于 0.3 Bar 会有气压过低的报警机器开不了的
3 Measure the AC input power is within 230V +/- 10%. Power
Consumption Max 10A.检查电源在 230 伏 正负 百分之十内.最大电
流 10 安培
3 Release E-stop Button.放开紧急停止按纽
3 Turn on the Main Power Switch.At Machine Front Right Middle
Position. 打开总电开关在机器前面右中位置
3 Computer will automatic Turn on. 计算机会自动开机
Dek Printer Training 4/70 25 June 2006
3 Please make sure the Under screen cleaner at the Front Home position.
If not, I will have an Screen Cleaner out of position Alarm 要把擦网纸
的部分拉到最前面原点的位置ｏ不然就会出擦网纸超出位置
3 Take out all Table’s tooling support pins.先把所有放在的顶针取出来
3 After computer boot up , it will automatic start the DEK Printer
Software.当计算机开了！自动会启动 DEK Printer 应用程序.然后出现
以下图像
It will do Dongle Initialised & Vision System initialised.先启动加密狗及相机初
始化
If Dongle Initialised Fail, please check the USB Key & Flash disk. 如果加密狗初
始失败，先检查一下加密锁及 U 盘有没有弄松
If Vision System initialized, Please check the IEEE1394 cable to Camera & PC.
如果相机初始化失败，先检查一下 IEEE1394 的线有没有弄松
3 Press System power Blue Button. It will Perform Reference Position 按蓝色
的按纽，自动回到原点！
3 Dongle initialized
3 Vision system unit
3 Squeegees(go to front & rear squeegees home sensor)
3 Rising table(go to table home sensor)
3 Camera(go to X & Y home sensors)
3 Print carriage(go to print carriage home sensor)
3 Screen changer(X fwd , X rear & Y offset motor home position)
3 Rail to board width(go to rail home sensor at 508mm)
3 Tooling(go to lifter table home sensor)
Dek Printer Training 5/70 25 June 2006
6. LOAD PRODUCT 运行程序
7. SETUP MENU 设定菜单
Dek Printer Training 6/70 25 June 2006