TDS_InJet_388_DOUBLE_TRIPLE_CRRD_ENG.pdf - 第2页

InJet ® 388 DOUBLE TRIPLE CRRD TECHNICAL DATA SHEET 2 www.dct.cleaning GENERAL INFORMATION The InJet 388 series cleaning systems represent unique vertical Spray-In-Air technology developed and manufactured by DCT. The ve…

100%1 / 8
www.dct.cleaning
TECHNICAL DATA SHEET
InJet
®
388
DOUBLE TRIPLE CRRD
www.dct.cleaning
CHAMBER
CHAMBER
STENCIL, MISPRINT, SQUEEGEE cleaning
PUMPRINT cleaning
PCB cleaning
InJet
®
388 DOUBLE TRIPLE CRRD 
TECHNICAL DATA SHEET
2
www.dct.cleaning
GENERAL INFORMATION
The InJet 388 series cleaning systems represent
unique vertical Spray-In-Air technology developed
and manufactured by DCT.
The vertically installed Spray-In-Air device minimizes the
shadowing eff ect commonly seen in horizontal cleaners,
and maximizes the effi ciency of the cleaning process as
the cleaning  uid is sprayed directly onto the cleaned
component.
InJet
®
388 DOUBLE TRIPPLE CRRD including 100%
closed loop with processes of cleaning, pre-rinsing,  nal
rinsing,
and drying technologies.
All of the processes are fully automated, and take place
in 3 process chambers. Cleaning takes place in the  rst
inlet chamber, after which the cleaned part is automatically
transported to the central chamber where the  rst rinsing
process takes place. The third, and last, outlet chamber is
designed for the  nal rinsing and the drying process.
All 3 chambers (inlet and outlet) can be used in
parallel, which increases machine’s capacity and reduces
cross-contamination when compared to single-chamber
devices. The machine has two positions on the PCB frame
(two slots), which means that at full capacity, 6 frames with
PCB are simultaneously processed.
Thus, the InJet
®
388 DOUBLE TRIPPLE CRRD delivers
twice the cleaning capacity of the InJet
®
388 TRIPPLE CRRD
and is therefore our most powerful vertical sprayer for
PCBA, for which it has also been developed.
The cleaning system can also be used for the high-capacity
removal of solder pastes and SMT adhesives from stencils,
PumPrints, squeegees and misprints.
Depending on your cleaning requirements,
the DCT project manager, in collaboration
with a local distributor, will advise you
on a suitable water-based cleaning fl uid
and the correct setup of the entire process.
InJet
®
388 DOUBLE TRIPLE CRRD 
TECHNICAL DATA SHEET
3
www.dct.cleaning
C
R
R
Application
name
Recommended
application
Recommended
temperature
Total cleaning
process time
Capacity
per 8 hours
Stencil, misprint, squeegee
20 – 40°C 68 – 104 °F 32 min. 96
PumPrint
40 – 55°C 104 – 131 °F 20 min. 96
PCB
35 – 55°C 95 – 131 °F 20 min. 1536 *
4 INDIVIDUAL PROCESSES
CLEANING PARAMETRES
C
CLEANING
PRE–RINSING
RINSING
DRYING
R
D
R
highly recommended recommended applicable
* PCB eurocards / per 8 hours (calculated for dimension of 100 x 160 mm / 3.94 x 6.3 in)
* * Parts in soldering palette / per 8 hours (320 x 500 x 50 mm / 12,6 x 19,7 x 1,97 in)
* * * Stencils, pumpprints larger than 736 x 736 mm / 29 x 29 in
LEGEND: