SLM_TechnicalReference(Eng_Ver14_07).pdf - 第12页
在线预览 SLM_TechnicalReference(Eng_Ver14_07).pdf PDF 文档。
Warning The machine should be moved wrapped in durable packing
materials and with covers for electrical protection.
Operating the machine without taking proper safety measures or
in an inappropriate place may cause damage to the machine or
personal death or injury.
If the door switch was removed artificially, since the equipment
does not stop even though the door opens during operation, the
user may get injured. Do not remove the door switch artificially.
Never attempt to modify the equipment without prior consent of
Samsung Techwin Co., Ltd. or repairs it in a manner not stated in
this manual. Samsung Techwin Co., Ltd. is not responsible for
problems caused by machine repairs performed in a manner not
mentioned in this manual, or any modifications carried out without
prior approval
Be sure to turn off the power switch and then close the air-valve
before maintenance or repair. If it is not followed, personal
injuries could occur.
Checking the sensor or correcting an error while the equipment
status is 'READY' could result in personal injury.
Press the 'EMG' switch to release the 'READY' and perform
sensor adjustment and take measures against the error after
pressing the 'STOP' button.
The system infected by a virus could make the machine
malfunction and the damage by malfunction could occur.
We do not take responsibility for any damage to the data due to
infection by a virus. Therefore, perform a virus check periodically
to prevent the data from being infected by a virus.
Observe the cautions when using the USB memory. (Refer to "2.3
PC Specification" of the Introduction Manual)
Page
SAMSUNG TECHWIN
1
SLM120/110
Contents
Mechanical Part
SO Optics Camera Ass'y.............................................................. 4
Feeder Base Ass'y ....................................................................... 8
Conveyor Ass’y........................................................................... 10
Backup Table Ass’y .................................................................... 24
Base Frame Ass’y ...................................................................... 26
Base Module Ass’y ..................................................................... 28
Head Ass’y ................................................................................. 30
Cutter Ass’y ................................................................................ 66
Air Ass’y...................................................................................... 70
Moving Frame Ass’y ................................................................... 78
Fixed ANC Ass’y......................................................................... 90
Cover Ass’y ................................................................................ 92
Control Rack Ass’y ..................................................................... 98
Electric Panel Ass’y .................................................................. 102
Electric Device Ass’y ................................................................ 106