TM6148.[Insert Length] added for insertion parts setting on YC8.pdf - 第3页

SM T Softwa r e Engine ering Group IM Ope r ation s Y AM AHA MOT OR CO ., L TD. Bef ore t his p arameter wa s ad ded , i t was adjus ted w i th [ A: Mounting He i ght ( mm)]. Howe v er , a ft er this setting was added, […

100%1 / 4
SMT Software Engineering Group
IM Operations YAMAHA MOTOR CO., LTD.
Target model and version are as follows.
Target Model and Version
Model Version Remarks
YC8 V3.42STD R1.000 or later
Y.Fact V1.42STD R1.000 or later
A setting parameter for mounting operation of the insertion parts has been added.
Additional parameter is as follows.
[Insert Length]
[Insert Length] is set as length included in [Body Size Z].
(See Fig. 2.1)
By setting [Insert Length], it becomes possible to mount insertion parts below the board
surface.
This parameter can be set separately to each of parts.
Set insertion length (mm) to [Parts] - [Mount] - [N:Insert Length].
(See Fig. 3.1)
SMT Software Engineering Group
IM Operations YAMAHA MOTOR CO., LTD.
Before this parameter was added, it was adjusted with [A: Mounting Height (mm)].
However, after this setting was added, [A: Mounting Height (mm)] means actual push amount.
By setting [Insert Length], it is possible to mout parts below the board surface.
(See Fig. 4.1)
When the insertion parts are mounted, the height of mounted parts above the board surface
(parts height) is calculated by subtracting [Insert Length] from [Body Size Z]. This value is used
as parts height before carry-in that is decided at line distribution by Optimization, or used at
interference check between mounted parts and picked parts.
SMT Software Engineering Group
IM Operations YAMAHA MOTOR CO., LTD.
Calculation of parts height is as follows.
1) On a machine with insertion parts unsupported, or no insertion parts are used on a
machine with insertion parts supported. ([Insert Length] = 0.000)
parts height = [Body Size Z]
2) Insertion parts are used on a machine with insertion parts supported.
([Insert Length] 0.000)
Parts height = [Body Size Z] – [Insert Length]
There are no error messages to be added in this function.
There are no restrictions in this function.