00193733-02.pdf - 第51页
SIPLACE F5 HM 2 Assembly Instructions PCB Camera, Multicolor SIPLACE F5 HM 05/2007 Edition 2.3 Requirements 51 2.3 Requirement s – Software versio n 407.01 o r later . 2.4 Assembly Kit s, T ools 2.4.1 Assembly Kit "…
2 Assembly Instructions PCB Camera, Multicolor SIPLACE F5 HM SIPLACE F5 HM
2.2 Safety Instructions 05/2007 Edition
50
Observe the guidelines of the Main Association of the German Trade Association, VBG 93.
In all other countries, comply with the pertinent guidelines and standards of the specific countries
in question.
Standards to be observed:
IEC 60825-1, EN 60825-1.
2
2.2.3 Definitions
DANGER
in terms of these instructions means that death, severe bodily injury or considerable material da-
mage WILL occur if the instructions about danger are not followed.
2
WARNING
in terms of these instructions means that death, severe bodily injury or considerable material da-
mage may occur if the warnings are not heeded. 2
CAUTION
in terms of these instructions mean that minor bodily injury or material may occur if the cautions
are not heeded. 2
NOTE
in terms of these instructions is a statement of important information about the product or the
pertinent portion of the instructions to which particular attention is being drawn. 2
2
SIPLACE F5 HM 2 Assembly Instructions PCB Camera, Multicolor SIPLACE F5 HM
05/2007 Edition 2.3 Requirements
51
2.3 Requirements
– Software version 407.01 or later.
2.4 Assembly Kits, Tools
2.4.1 Assembly Kit "PCB Camera Multicolor F5 HM"
1 Unit Assembly kit "Multicolor for F5 HM", item no.: 00358028-01, consisting of: 2
- PCB camera Multicolor Item no. 00355462-01 1 unit
- Assembly kit V50 currency Item no. 00357863-01 1 unit
2.4.2 Additional Material Required
- Cable tie L x W = 140 x 3.6 mm Item no.: 00805141-01 x units
- Cable clamp, size 6. Item no.: 00805503 8 units
- Aderendhülsen xxxxxxxx 5 units
NOTE:
No additional screws are needed to mount the PCB camera Multicolor. The captive screws are on
the PCB camera Multicolor. 2
2.4.3 Tools, Auxiliary Test Equipment and Expendable Materials
– Set of Allen wrenches
– Oblique-nosed cutting pliers
– Wire stripper
– ESD bracelet
– Small mirror to be used as an aid while installing/removing the PCB camera
2 Assembly Instructions PCB Camera, Multicolor SIPLACE F5 HM SIPLACE F5 HM
2.5 Preparatory Steps 05/2007 Edition
52
2.5 Preparatory Steps
: Open the safety hoods and the safety doors on the area of component feeders.
: Push the gantry out of the vicinity of the component changeover table until it is above the PCB
conveyor area.
: Turn the machine off at the main switch, isolate the machine from the mains, turn OFF the flow
of compressed air at the compressed air unit (see DANGER text in Abschn. 2.2).
: Push the X-gantry toward the outside of the machine so that the placement head is readily ac-
cessible.