Release-R17-1-CS_Reporting_en.pdf - 第10页

T ouchless Placement Process ASM Assembly Systems Zero Placement force  Application for very f ragile component  Accurate process control of placement into the flux/solder etc. V acuum tooling to make sure PCB is flat …

Touchless placement

8/8/2017 ASM Assembly Systems Page 9

Precondition/Settings in SIPLACE Pro

- Defined height measurement point

on the board, min.3 points.

- Choose in the Component Shape Editor „Touchless Placement”.

- All settings will be generate automatically, without the „Z-Height“ – Tolerance

Sequence on the station

- Input the PCB and recognize the fiducial.

- Measurement the „height measurement points“ with the Z-axis and check the level with the defined tolerance

- New errormessages are possible:

32438 „Z position out of range…“

32439 „Slope detection…“

Touchless Placement Process

ASM Assembly Systems

Zero Placement force

 Application for very fragile

component

 Accurate process control of

placement into the flux/solder

etc.

Vacuum tooling to make sure

PCB is flat positioned and supported

Height measurement for

PCB leveling prior to placement

Place component with accurate Z axis

height control based on PCB leveling

∆ Controlled

08.08.2017 Page 10

SIPLACE Pro - Ease of Use 2.1: Updating an existing Setup

8/8/2017 ASM Assembly Systems Page 11

In case customers change the hardware of a station or replace a station in a line all existing setups need to be updated manually.

With this feature SIPLACE Pro support to change a station type within an existing setup.

This feature consist of two parts.

1. Update of an existing Setup/Line/Station(s) by uploading the current station configurations with the same station types and line

layout. e.g. a camera has changed or the nozzles in the nozzle changer have changed

2. Copy of Feeder and Nozzle configuration between the setups of two lines with different number of stations and different station

types.

The user creates the new line (manually or automatically), creates an empty setup and can get the nozzle and feeder setup from

the old setup. The user can decide to copy only the nozzle changer configuration, only the feeder setup or both.