Manuelles Tray an D1 an Stellplatz 2.pdf - 第21页

Special Design 2 Assembly instructions Special des ign for manual tray at location 2 SIPLACE D1 05/2007 Edition 21 : Disassemble the limit s witch from the bracket. 2 : Disassemble the br acket for the left lim it switch…

100%1 / 26
2 Assembly instructions Special design for manual tray at location 2 SIPLACE D1 Special Design
05/2007 Edition
20
2.7.2 Adjusting the limit switch for the conveyor width
: Open the mini output flap.
: Remove the covers from the conversion board at the output conveyor.
2
2
: Disassemble the bracket for the right limit switch removing 2 screws.
2
Covers of conversion board
Bracket
Special Design 2 Assembly instructions Special design for manual tray at location 2 SIPLACE D1
05/2007 Edition
21
: Disassemble the limit switch from the bracket.
2
: Disassemble the bracket for the left limit switch removing the two screws.
2
Disassemble the bracket
Bracket
2 Assembly instructions Special design for manual tray at location 2 SIPLACE D1 Special Design
05/2007 Edition
22
: Disassemble the limit switch from the bracket.
: Assemble the new bracket for the limit switches using the screws you removed before.
2
Use only the upper screws to assemble the new bracket so that you still can turn the bracket to
assemble the covers for the conversion boards. 2
2
: Assemble the left limit switch on the new bracket at the left side of the output conveyor.
: Assemble the right limit switch on the new bracket at the right side of the output conveyor so
that the side panel from the conveyor can not crash with the tray holder.
2
: Currently the cable is routed underneath the cover from the conversion board.
Route the cable from the right limit switch underneath the right or left cover from the conversion
board to the notch from this cover.
2
2
: Assemble the covers from the conversion board.
: Fix the new bracket with the other two screws and tighten all screws from the new bracket.
: Locate the cable approximately in the middle of the right cover from the conversion board with
two self-adhesive cable clamps. Clean the surface before with ethyl alcohol and a lint-free
cloth.
Notch
Cable routing