E By DEK Operator Manual 英文版.pdf - 第4页
E STOP OPERA TION SAFETY INTERLOCKS TRI COLOUR BEACON PRINTHEAD COVER With the machine powered up, activating the red Emergency Stop button (E Stop) causes the machine to stop in a controlled manner . The safety features…
2
SAFETY
GENERAL
HAZARDOUS MATERIALS
HAZARDOUS AREAS
quick guide to the general operating conditions of the machine.
procedures in addition to specific safety precautions laid down in this
manual.
WARNING notices draw the attention of operators to possible hazards
which may cause loss of life, serious injury or ill health.
safe at all times, all personnel must follow generally accepted safety
This manual should be used by suitably trained machine operators It is a.
CAUTION notices alert personnel to the possibility of damage occurring to
the machine material.
To ensure that the operating conditions for the printing machine remain
The following label, illustrated below, may be fitted to the machine. This
signifies that the user should refer to the operator manual before
attempting to carry out work on the equipment.
Hazardous materials, as defined by 497 (National Fire Protection
Association), are not recommended by for use on this machine If one
or more hazardous materials are used, decontamination must be carried
out in accordance with S12 or equivalent local regulations.
NFPA
ASM .
SEMI
i
E STOP OPERATION SAFETY INTERLOCKS
TRI COLOUR BEACON
PRINTHEAD COVER
With the machine powered up, activating the red Emergency Stop button
(E Stop) causes the machine to stop in a controlled manner.
The safety features designed into the printer are for the protection of all
operators and maintenance personnel. strongly recommend safety
devices are never overridden.
ASM
The default settings for the beacon indicates the operational status of the
machine:
To activate:
press the E Stop button, electrical power to the machine
is suspended.
To reset:
turn the E Stop button clockwise until it unlatches.
Raising the printhead cover suspends operation of the machine to allow
the operator safe access to the tooling area.
i
SAFETY
Beacon Colour
Operational Status
Machine is not operational
System power is down
Error message displayed
Paper roll is empty
Solvent tank level is low
Machine is not in a ready state
Machine is initializing
Machine is in set up
Machine is in maintenance
Machine is operational
Machine is waiting in a ready state
3
KEY
4
DAILY MAINTENANCE
Escalate to an Engineer
Inspect items for contamination
Items are clean
Clean contaminated area with correct
cleaning product and dispose of in
refuse bin
Clean contaminated area with soapy
water and dispose of in container
USER INTERFACE
i
Machine Recognition
Individual Select
Sequential Select
Wait for Action to
Complete
Tutorial Available
1
1
2
3