SM_SXDX12_intern_03-2017_en.pdf - 第22页
Service Work Exchange / Demounting of Y-Magnets 22 Service Manual (Internal) SIPLACE SX1/SX2/DX1/DX2 Mount Magnet ▪ Before assembly t he magnets on the last magnets, insert th e Te flo n plate and the safety pad . Place …
Service Work
Exchange / Demounting of Y-Magnets
Service Manual (Internal) SIPLACE SX1/SX2/DX1/DX2 21
▪ The metal plate with the security inscription support is always at the top so that you can read them
on the handset. See picture.
▪ Loosen the magnet while holding firmly the magnet along with support. After removing the last screw,
remove the magnet carefully from the outside and tilt.
Caution! Please consider the notes from
00195600 - TI Safety note monorail, D + E
Magnets must be dismantle only from the outside
to the inside.
Get an additional person to help you on the work
with the magnets.
NOTICE
Exchange guide carriages / loose bearing y-axis
It must be dismantled three magnets on both sides.
Before dismantling the magnets, insert the Teflon plate and the safety support in all magnets ,
as shown in the picture . (When sharing the carriage / loose bearing y-axis on the outer 3) so
you avoid scratching the magnets.
Service Work
Exchange / Demounting of Y-Magnets
22 Service Manual (Internal) SIPLACE SX1/SX2/DX1/DX2
Mount Magnet
▪ Before assembly the magnets on the last magnets, insert the Teflon plate and the safety pad. Place
the spacer for Y magnets [03065304-xx] between the magnet and machine base.
▪ Place the magnet with safety pad on the machine frame and push it gently into the mounting position.
WARNING
Magnetic force 400kg
Place the magnets never unsecured on a work surface. When storing the magnets use always
the prescribed packaging as
„Cardboard lid for 03064172-01“ [03082592-xx] and with the safety cover.
NOTICE
Please keep an eye on the magnet Pollrichtung "N". This must be the same for all the magnets
on one side.
DANGER
The magnets attract each other and there is a risk to squeeze the fingers between the magnets.
Service Work
Exchange / Demounting of Y-Magnets
Service Manual (Internal) SIPLACE SX1/SX2/DX1/DX2 23
▪ Keep holding the magnets so long until this is fixed with the first screw.
▪ Turn the remaining ones bolts. Press the magnet against the spacer and tighten the bolts with a
torque wrench with 9 Nm.
▪ Install the remaining magnets successively by preserving this way of working.
Finally, remove the safety covers by lifting them slightly, pull on the Teflon plate and lift them whole.
Thereby you avoid scratching the magnets.