Integration Stanzförderer.pdf - 第13页
Retrofit Instructions - Special Design for Integrating the Punching Die Feeder for t he HF series 11/2004 Edition 13 2.3 R etro fit The feed er can on ly be set up on table 2 , loca tion 49 - 90. 2 : Bolt the f eeder tig…
Retrofit Instructions - Special Design for Integrating the Punching Die Feeder for the HF series
11/2004 Edition
12
2.2 Safety instructions
WARNING
The safety instructions from the “Operational safety” chapter of the user manual and servicing in-
structions take precedence over these instructions. 2
The SIPLACE placement machines are supplied with mains voltage.
Consequently parts of these systems carry dangerous voltages! This voltage is present at certain
modules inside the machine base, even when the machine is switched off at the main power
switch. 2
Incorrect handling of the placement machine or touching live parts of the machine can result in
death or severe injury, and considerable damage to equipment. 2
BEFORE starting any work, shut down the operating system correctly, then switch the machine
OFF at the main power switch and disconnect from the main power supply. In addition, the com-
pressed air supply must be switched off at the compressed air unit's main valve in the machine
base and vented by actuating the needle valve on the compressed air unit. 2
There is DANGER for heart pacemaker wearers in the vicinity of the linear motors, as described
in detail in the "Special safety instructions for working in the vicinity of strong magnetic fields" sec-
tion of the user manual and service manual. 2
Always follow the accident prevention regulations, DIN or other standards and special safety rules
applicable in your country.
Pay attention to the information concerning residual voltages in the Operational Safety chapter.
Follow the ESD regulations as described in the operational safety section of the operating instruc-
tions.
During the retrofit, always secure the machine to prevent access by other people and to prevent
it being switched on again. The procedure is described in the “Locking the machine…” section of
the user manual.
Working with the SITEST program further increases the risk of accident.
The SITEST program must only be used by authorized and trained personnel. 2
2
2.2.1 Definition
2
PLEASE NOTE 2
2
Retrofit Instructions - Special Design for Integrating the Punching Die Feeder for the HF series
11/2004 Edition
13
2.3 Retrofit
The feeder can only be set up on table 2, location 49 - 90. 2
: Bolt the feeder tight to the component table.
: Attach a suitably modified protective cover.
To do this, you will have to fit a hand guard to the feeder.
2
2
Retrofit Instructions - Special Design for Integrating the Punching Die Feeder for the HF series
11/2004 Edition
14
The component table must be mechanically secured to prevent the component table moving out
unintentionally. 2
: To do this, fix the safety bracket to the component trolley.
2
2
2
2
2
2
2
2
2
2
2
2
2
2