00198356-01_AI_Input-Extension_SX12_DE_EN_web.pdf - 第59页
Assembly Instructions / Montageanleitung SIPLACE SX1/SX2 V2 Option Input Conveyor Extension 05/2017 3 Installation 3.4 Installing the belt guide extension 59 3.4 Installing the belt guide extension This section describes…
3 Installation
3.3 Preparing the extensions
Assembly Instructions / Montageanleitung SIPLACE SX1/SX2 V2
Option Input Conveyor Extension 05/2017
58
3.3 Preparing the extensions
This section describes how to prepare the input conveyor extensions for the installation:
●
Input conveyor extension A/C complete [03127428-xx]
●
Input conveyor extension B/D complete [03127427-xx]
NOTICE
Example
The "Input conveyor extension A/C complete" [03127428-xx] is taken as an example to
show the preparation of the extensions.
The preparation of the "Input conveyor extension B/D complete" [03127427-xx] follows the
same procedure.
Mounting the stiffening bar (example shows the con-
veyor rail A/C)
1. Stiffening bar (idler pulley mount) [03127457‑xx]
2. Belt guide extension [03127426‑xx]
3. Idler pulley [03099834‑xx]
► Use three screws of type ISO4762-M3x12-A2-70
[03042544 xx] to fasten the stiffening bar(1) to
the belt guide extension(2).
► Dismount the idler pulley (3) from the dismantled
belt guide and mount it on the belt guide exten-
sion.
► Repeat these steps for all conveyor rails.
Assembly Instructions / Montageanleitung SIPLACE SX1/SX2 V2
Option Input Conveyor Extension 05/2017
3 Installation
3.4 Installing the belt guide extension
59
3.4 Installing the belt guide extension
This section describes how to install the belt guide extensions on the machine:
Fig.11: Belt tensioning with belt guide extension (example shows conveyor rail A/C)
Fig.12: Toothed belts and drive
► Thread in the toothed belt (L=1653mm)
[03127522‑xx].
See also: 4.1.5 "Replacing the Toothed Belt
(Conveyor Belt)" [}68].
► Mount the belt guide extension on the conveyor
(torque 6 Nm).
See also: 4.1.4 "Replacing the clamping rail and
belt guide" [}66].
► Mount the drive (torque 1.7 Nm).
See also: 4.1.2 "Replacing the Tape Drive
[03092315-xx]" [}64].
► Mount the hexagonal shaft.
See also: 4.1.1 "Replacing the Hexagonal Shaft
[03094006-xx]" [}63].
► Repeat these steps for all conveyor rails.
3 Installation
3.5 Mounting the hand guard belt extension
Assembly Instructions / Montageanleitung SIPLACE SX1/SX2 V2
Option Input Conveyor Extension 05/2017
60
3.5 Mounting the hand guard belt extension
Fig.13: Adapter plate
► Use four screws (2) [03042572‑xx] to fasten the
adapter plate (1) [03121015‑xx] to the input side
of the machine.
Fig.14: Removing the top cover
► Remove both screws(1) that fasten the top
cover.
ð You can now flip open the top cover. This sim-
plifies installing the hand guard belt extension.
Fig.15: Mounting the hand guard belt extension
► Lift the hand guard belt extension (1)
[03119279‑xx] to the machine. Use an appropri-
ate tool if necessary (e.g. a crane).