00197463-03_SM_CPP_Customer_EN.pdf - 第45页

5 Front plate, star, Z axis and smoothed distributor disc 5.2 Removing and fitting the star (only for heads from FS05 upwards) Service Manual SIPLACE Multistar (CPP / CPP M) 02/2018 45 Installation Fig.59: Correct posit…

100%1 / 120
5 Front plate, star, Z axis and smoothed distributor disc
5.2 Removing and fitting the star (only for heads from FS05 upwards)
44 Service Manual SIPLACE Multistar (CPP / CPP M) 02/2018
Fig.56: Handle
► Remove the two screws (1) fastening the camera
cover (2) and remove the camera cover.
► If required, dismantle the front plate.
5.1 "Replacing the front plate [03061102-xx]" [}35]
► Remove the screwed joint.
8.2 "Replacing the screwed joint" [}94]
Fig.57: Disconnecting the nozzles and hoses
► Pull the nozzle (1) off the DP drive.
► Pull the DP drive (2), together with the jaws, out
of the head.
 CAUTION!
Do not pull on the black cover. This might break
if you do.
.
► Remove the hose(3) on both sides.
► Repeat these steps for all twelve DP drives.
Fig.58: Screws fastening the star
► Remove the twelve screws fastening the star.
These twelve screws are between the DP drives
in each case.
► Carefully pull the complete star assembly off the
star motor. While doing so, hold the star on the
SCS.
5 Front plate, star, Z axis and smoothed distributor disc
5.2 Removing and fitting the star (only for heads from FS05 upwards)
Service Manual SIPLACE Multistar (CPP / CPP M) 02/2018 45
Installation
Fig.59: Correct position of the smoothed distributor disc
 CAUTION!
Make sure that the smoothed distributor disc (1)
is fitted correctly between the back plate and the
star (grooves). The pins on the smoothed distrib-
utor disc must point in the direction of the back
plate.
.
Fig.60: Pin
► Insert the star into the head.
 CAUTION!
When inserting the star, make sure that the pin
on the head is inserted into the relevant recess
on the star.
.
Fig.61: Fastening the star
► Fasten the star with the twelve screws.
Tighten the screws crosswise with a torque of
0.20Nm.
5 Front plate, star, Z axis and smoothed distributor disc
5.2 Removing and fitting the star (only for heads from FS05 upwards)
46 Service Manual SIPLACE Multistar (CPP / CPP M) 02/2018
Fig.62: Connecting the hoses
► Use the tweezers to push the hoses onto the
connections.
– Take care of the correct hose orientation.
– Make sure you do not damage the hoses.
– See also: 6.3 "Replacing the DP Drive Hose
[03015920Sxx]" [}75]
► Follow the removal instructions in reverse order for further installation.
Also observe the installation instructions in the following section:
8.2 "Replacing the screwed joint" [}94]
5.1 "Replacing the front plate [03061102-xx]" [}35]
► Observe in particular the torques specified!