manual-phse-preheater-jbc-0026748_ID-204617_EN.pdf - 第13页
Safety It is i mp er at ive to fo ll ow sa fet y g ui de lin es to p reve nt e le ct r ic sh ock , in ju r y, fir e or ex plo si on . - Do n ot use th e un its fo r any p ur po se othe r th an PC B pre he ati ng. In cor …
Maintenance
- Before carrying out maintenance or storage, always
allow the equipment to cool down.
- Check periodically that the equipment is clean.
- Use a damp cloth when cleaning. Alcohol can only
be used to clean the metal parts.
- Only if it is absolutely necessary and if cleaning
with isopropyl alcohol (IPA) is not enough, it is
recommended to use a scraper to remove dirt in
the glass area.
- Replace any defective or damaged parts. Use original
JBC spare parts only.
- Repairs should only be performed by a JBC authorized
technical service.
1
1
12
Fuse Holder
Fuse Holder
Fuse
Clean periodically
Reference for Replacement Fuse:
- PHSE-9B (100V), fuse T10A Ref. 0032666
- PHSE-1B (120V), fuse T10A Ref. 0032666
- PHSE-2B (230V), fuse T5A Ref. 0032687
- A blown fuse can be replaced by the user itself.
The fuse is located between the power supply
connector and the on/off switch (1). To replace a
blown fuse, proceed as described below.
Important: make sure that the preheater
is disconnected from the
power supply.
Pull out the fuse holder, if necessary use
a tool to lever it off.
Take the blown fuse out and press the
new one into the fuse holder. Finally clip
the fuse holder back into place.
Safety
It is imperative to follow safety guidelines to prevent electric
shock, injury, fire or explosion.
- Do not use the units for any purpose other than PCB preheating. Incorrect use may cause a fire.
- The mains cable must be plugged into approved bases. Make sure that it is properly grounded
before use. When unplugging it, hold the plug, not the wire.
- The temperature of accessible surfaces may remain high after the unit is turned off. Handle with care.
- Do not leave the appliance unattended when it is on.
- Do not cover the ventilation grills. Heat can cause inflammable products to ignite.
- Heat can cause inflammable products to ignite even when out of sight.
- Be careful with the remains of liquid tin. In contact with the skin, it can cause burns.
- Avoid flux coming into contact with skin or eyes to prevent irritation.
- Be careful with the smoke produced when soldering.
- Keep your workplace clean and tidy. Wear appropriate protection glasses and gloves when working
to avoid personal harm.
- This appliance can be used by children over the age of eight as well as persons with reduced physical,
sensory or mental capabilities or lacking experience provided that they have been given adequate
supervision or instruction concerning the use of the appliance and understand the hazards involved.
Children must not play with the appliance.
- Maintenance must not be carried out by children unless supervised.
Maintenance
- Before carrying out maintenance or storage, always
allow the equipment to cool down.
- Check periodically that the equipment is clean.
- Use a damp cloth when cleaning. Alcohol can only
be used to clean the metal parts.
- Only if it is absolutely necessary and if cleaning
with isopropyl alcohol (IPA) is not enough, it is
recommended to use a scraper to remove dirt in
the glass area.
- Replace any defective or damaged parts. Use original
JBC spare parts only.
- Repairs should only be performed by a JBC authorized
technical service.
13
40 mm
50 mm
60 mm
80 mm
100 mm
130 mm
130 mm
para manuales - color gris
200 mm
300 mm
Notes
14