TS5440.pdf - 第9页
9 9. SPARE PARTS AND ACCESSORIES 9.1 Spare Parts: The seal replacement kit, part number = 5440-SE ALKIT, includes: FLUID INLET FITTING O-RING (5) O-RING (8) MYLAR WASHER (16) O-RING (10) NYLON WASHER (9) CUP SEAL (27) O-…
8
8. MAINTENANCE AND CLEANING:
Tool required: 7/64” hex wrench; 7/16” open-end wrench; Snap ring pliers, O-ring tool.
Normally, purging the valve with appropriate flush material or solvent after use is sufficient for
cleaning. However some material may cause a buildup in the valve chamber, in this case periodic and
thorough cleaning will be required.
NOTE:
• To replace seals, please order seal kit part number: 5440-SEALKIT
• To repair valve, please order valve kit part number: 5440-VALVEKIT
CAUTION: Make sure the fluid pressure is released before disassemble the valve.
Refer to figure 5.0
1) Release fluid pressure.
2) Disconnect fluid line.
3) Disconnect valve air hose.
4) Unscrew retaining cap (1) and remove the dispense needle.
5) Remove the three mounting screw (17).
6) Pull the fluid housing (4) away from the air cylinder (11).
7) Remove the luer adapter assembly (2) from the fluid housing (4).
8) Clean and inspect the needle assembly (8), luer adapter assembly (2) for wear and
damage. Replace parts as necessary.
9) Replace O-ring (7) if necessary. Make sure to lubricate new O-ring with approved
lubricant.
10) Reinstall the luer adapter assembly (2) to the fluid housing (4).
11) Align the fluid housing (4) to the air cylinder (11) and reinstall the three mounting
screws. (Alternately tighten the screws a little at a tim e until they are secure.
13 14
3465789101112
1
2
1615 17
TS5440
XXXX
Figure 5.0
9
9. SPARE PARTS AND ACCESSORIES
9.1 Spare Parts:
The seal replacement kit, part number = 5440-SEALKIT, includes:
FLUID INLET FITTING
O-RING (5)
O-RING (8)
MYLAR WASHER (16)
O-RING (10)
NYLON WASHER (9)
CUP SEAL (27)
O-RING (11)
5440-SEALKIT
REPAIR KIT, NEEDLE VALVE
The valve repair kit, part number = 5440-VALVEKIT, includes:
5440-VALVEKIT
REPAIR KIT, NEED LE VALVE
FLUID INLET FITTING
LUER ADAPTER (2)
RETAINING RING (10)
NEEDLE ASSEMBLY (4)
RETAINING RING (6)
SEALKIT
MOUNTING SCREWS (17)
Figure 6.0
10
9.2 Standard Accessories:
9.3 Optional Accessories:
The flowing three components are needed to make a bench mounting stand:
PART NUMBER DESCRIPTION
918-033-000 Production master stand
918-000-012 Rod Clamp
5620-000-008 Mounting rod
PART NUMBER DESCRIPTION
918-000-048 Bracket
9000-000-112 Sample needles kit
TSD126-360BK Black fluid line
TE SERIES NEEDLE
PART NUMBER Gauge Hub Color ID(in)
TE722050PK
22
Blue
.016
TE723050PK
23
Orange
.013
TE725050PK
25
Red
.010
TE727050PK
27
Clear
.008
TE730050PK
30
Lavender
.006
TE732025PK
32
Yellow
.004