4000 Bauelemente auf Basis SV 408-01-SP0.pdf - 第19页
SOKO SOKO 4000 Componente / Gantry 05/2006 Edition 19 2 Inst allation manual SOKO „4000 component s / gantry“ for CF / CS / F5HM based on S t ation SW version 408.01.SP0 (00166272-01) 2.1 General information This documen…
SOKO 4000 BE / Portal
Ausgabe 05/2006
18
SOKO SOKO 4000 Componente / Gantry
05/2006 Edition
19
2 Installation manual
SOKO „4000 components / gantry“
for CF / CS / F5HM based on Station
SW version 408.01.SP0 (00166272-01)
2.1 General information
This document describes the contents and the installation of SOKO „SOKO 4000 placement 2
positions“ for SIPLACE version 408.01 servicepack 0. 2
This SOKO will only work for machine types SIPLACE F5HM / SIPLACE CF / SIPLACE CS. 2
You can not use this SOKO with other types of machine! 2
The software can only be used with SIPLACE Pro 3.2. 2
2.2 Limitations
You can not use Koplan with this SOKO installed. 2
The distributer has to be started after deinstallation of the SOKO. 2
2.3 Scope of delivery
– CD-ROM: 1 Software package for machine
– Description of SOKO for station-software 408.01 SP 0
The CD contains the modules for the machine types 2
– SIPLACE F5HM
– SIPLACE CF
– SIPLACE CS
2
2
SOKO 4000 Componente / Gantry SOKO
05/2006 Edition
20
2.4 Safety instructions
WARNING
The safety instructions from the “Operational safety” chapter of the user manual and servicing in-
structions take precedence over these instructions. 2
The SIPLACE placement machines are supplied with mains voltage.
Consequently parts of these systems carry dangerous voltages! This voltage is present at certain
modules inside the machine base, even when the machine is switched off at the main power
switch.
Incorrect handling of the placement machine or touching live parts of the machine can result in
death or severe injury, and considerable damage to equipment.
BEFORE starting any work, shut down the operating system correctly, then switch the machine
OFF at the main power switch and disconnect from the main power supply. In addition, the com-
pressed air supply must be switched off at the compressed air unit's main valve in the machine
base and vented by actuating the needle valve on the compressed air unit.
There is DANGER for heart pacemaker wearers in the vicinity of the linear motors, as described
in detail in the "Special safety instructions for working in the vicinity of strong magnetic fields"
section of the user manual and service manual.
Always follow the accident prevention regulations, DIN or other standards and special safety
rules applicable in your country.
Pay attention to the information concerning residual voltages in the Operational Safety chapter.
Follow the ESD regulations as described in the operational safety section of the operating
instructions.
During the retrofit, always secure the machine to prevent access by other people and to prevent
it being switched on again. The procedure is described in the “Locking the machine…” section of
the user manual.
Working with the SITEST program further increases the risk of accident.
The SITEST program must only be used by authorized and trained personnel.
2