00194340-01.pdf - 第32页
Retrofit Instructions & User’s Manual / Automatic Vacuum Support Pins (AVSP) Edition 04/2006 → Mount the option plate on lifting table. Mounted op tion plate as shown in Figure 2.4.4-4. → Continue to assemble distrib…
Retrofit Instructions & User’s Manual / Automatic Vacuum Support Pins (AVSP)
Edition 04/2006
→ Connect 3 tubing from distributor assembly (Item No.: 03040773-FS for dual conveyor,
03040851-FS for single conveyor) to control unit and lay the tubes under lifting table as
shown in Figure 2.4.4-2.
Figure 2.4.4-2 Air interface tubing from control unit to distributor
→ Connect the 3 tubes coming out from lifting table’s bottom to distributor assembly. Follow
by mounting the distributor to AVSP option lifting table top plate (Item No.: 03046506-FS
for single conveyor, 03047412-FS for dual conveyor).
Figure 2.4.4-3 Air interface tubing from control unit to distributor
2-27
Retrofit Instructions & User’s Manual / Automatic Vacuum Support Pins (AVSP)
Edition 04/2006
→ Mount the option plate on lifting table. Mounted option plate as shown in Figure 2.4.4-4.
→ Continue to assemble distributor on any other placement areas where AVSP is required.
→ Mount all dismounted lifting table top plate and PCB cover to its original location.
Figure 2.4.4-4 Mounted option plate
2-28
Retrofit Instructions & User’s Manual / Automatic Vacuum Support Pins (AVSP)
Edition 04/2006
2.5 Pin module installation
→ Adjust conveyor’s width to the exact width for PCB according to procedures stipulated in
user manual of SIPLACE HS-60. Make sure the width is at acceptable level by running
the PCB thru the whole conveyor length.
→ After adjusting the conveyor’s width, quit the session before installing the pin module.
Power OFF machine.
WARNING
Do not readjust the conveyor’s width once the pin module is installed. If readjustment is
necessary in any circumstances, remove the pin module(s) and tubing connected to it from
lifting table before adjustment.
→ Connect the L-fitting on pin module (Item No.: 03031408-FS) to distributor. Make sure
ports are connected correctly according to the alphabet code.
WARNING
Misconnection of ports may result in pin module not functioning correctly and may caused
damaged to pin module.
2-29