00197279-03_SM_Glue-Feeder_EN.pdf - 第39页
Replacing Spare Parts 3.13.1 Removing the Jet Block Jet Block (Spare Fluidic) Service Manual SIPLACE Glue Feeder 39 ► Loosen the 4 screws whic h fasten the jet block. ► Carefu lly lever the jet block vertically up and of…
Replacing Spare Parts
Jet Block (Spare Fluidic) 3.13.1 Removing the Jet Block
38 Service Manual SIPLACE Glue Feeder
3.13
3.13 Jet Block (Spare Fluidic)
Jet Block (Spare Fluidic)
Required spare parts
Spare fluidic, item no. 03094177-xx
Tools and equipment required
▪ Open-ended wrench, size 8
▪ Heating key (on the glue feeder)
▪ Antistatic tweezers, item no. 00377394-01 (service kit)
▪ Allen key size 2.5
▪ Disposable protective gloves
▪ 2 O-rings for plunger
▪ Grease (Barrieta L55/3)
3.13.1
3.13.1 Removing the Jet Block
Removing the Jet Block
CAUTION
Poisonous and hazardous substances
To avoid direct contact with the glue, always wear protective gloves during this work.
► Remove the cartridge pipe, nozzle heating and car
-
tridge into place (see "3.11.1 Removing the Cartridge
Pipe" [ ➙ 29])
► Lift the dispenser nozzle off the jet block.
Replacing Spare Parts
3.13.1 Removing the Jet Block Jet Block (Spare Fluidic)
Service Manual SIPLACE Glue Feeder 39
► Loosen the 4 screws which fasten the jet block.
► Carefully lever the jet block vertically up and off the jet
plunger.
► Turn the jet block so that the underside is at the top.
► Use a pair of antistatic tweezers to help you remove
the O-ring.
► Use a lint-free cloth with a little glue remover and
clean the jet plunger.
► Use a pair of antistatic tweezers to pull the O-ring up
and over the jet plunger.
Replacing Spare Parts
Jet Block (Spare Fluidic) 3.13.2 Fitting the Jet Block
40 Service Manual SIPLACE Glue Feeder
3.13.2
3.13.2 Fitting the Jet Block
Fitting the Jet Block
CAUTION
Poisonous and hazardous substances
To avoid direct contact with the glue, always wear protective gloves during this work.
NOTICE
Replacing O-rings
Damaged O-rings are no longer able to fulfil their sealing function. As a result, the pressure re
-
quired at the jet valve can not be produced to its full extent and glue may protrude, contaminat
-
ing the inside of the glue feeder.
We therefore recommend that you also replace the O-rings.
► Clean the jet plunger with a cleansing tissue and a lit
-
tle glue remover.
► Carefully push the O-ring onto the size 2.5 Allen key.
► Open the grease container.
► Slowly insert the Allen key with the O-ring into the
grease container and coat the O-ring with a little
grease.